MS for finish painting work

Aim: The aim of works is to describe painting installation works for carbon steel pipe, support, tray/trunking…to ensure compliance with contract requirements approved shop drawings, ma

I General

II Aim III Scope of works

IV Methodology

1 Carbon steel pipe system

2 Support system

3 Tray - Trunking system

I General:

Items: - The Method Statement For Painting Works

II Aim:

The aim of works is to describe painting installation works for carbon steel pipe, support, tray/trunking…to ensure compliance with contract requirements approved shop drawings, materials, specification and quality control

This scope of work shall include painting system of the SAIGON M&C TOWER

project

III Methodology:

1) Before primer, all dirt, dust, grease, oil or other foreign matters shall be removed

by scrapers, wire brushes and solvents

2) All finished surfaces shall be free from runs, drops, ridges, waves, laps, brush marks and variations in color, texture and finish Coverage shall be complete, and each coat shall be so applied as to produce a film of uniform thickness Special attention shall be given to ensure that all surfaces including edges, corners, crevices, welds and rivets receive a film thickness equivalent to that of adjacent painted surfaces

3) Adjacent areas and installations shall be protected by the use of masking tape, drop cloths or other approved precautionary measures Metal surface adjacent to surfaces to receive water thinned paints shall be primer and/or touched-up prior

to the application of water thinned paints

4) The first coat on render or board finishing shall include such repeated touching

up of suction spots to produce a uniform color

5) Paint only in a well-ventilated area for avoided poisoning with thinner

6) Attention to all material and floor on the painting area for avoid paint dripping and damages

7) Colour of paint shall be showed as table 1

Table 1: Paint colour schedule

System Colour of Primer coat Colour of Finishing paint Remarks

Tray -Trunking By manufacture By manufacture Approved by

the engineer

1 Carbon steel pipe system

# Step by step painting:

? Clean the pipe surface, removed all dirt, dust, oil, grease…etc

? Primer coat (Primer shall be one coat) ? Second coat (Finish painting shall be two coat)

a) Primer coat (Anticorrosive paint)

ƒ Spreading rate: 0.182kg/m2/coat

ƒ Paint brush or roller coating

ƒ Colour of paint follow table 1

b) Second coat (Finishing paint)

ƒ Spreading rate: 0.059kg/m2/coat

ƒ Paint brush or roller coating

ƒ Colour of paint follow table 1

2 Support system

? Clean support, removed all dirt, dust…etc

? Primer coat (Anticorrosive paint) Primer coat (Anticorrosive paint)

ƒ Spreading rate: 0.182kg/m2/coat

ƒ Paint brush or roller coating

ƒ Colour of paint follow table 1

Illustration for finish painting work