Microsoft Word C055364e doc ICS 55 100 Ref No ISO 9100 2 2005/Cor 1 2009(E) © ISO 2009 – All rights reserved Published in Switzerland INTERNATIONAL STANDARD ISO 9100 2 2005 TECHNICAL CORRIGENDUM 1 Pub[.]
Trang 1ICS 55.100 Ref No ISO 9100-2:2005/Cor.1:2009(E)
© ISO 2009 – All rights reserved
Published in Switzerland
INTERNATIONAL STANDARD ISO 9100-2:2005
TECHNICAL CORRIGENDUM 1
Published 2009-11-15
INTERNATIONAL ORGANIZATION FOR STANDARDIZATION • МЕЖДУНАРОДНАЯ ОРГАНИЗАЦИЯ ПО СТАНДАРТИЗАЦИИ • ORGANISATION INTERNATIONALE DE NORMALISATION
Glass containers — Vacuum lug finishes —
Part 2:
33 medium
TECHNICAL CORRIGENDUM 1
Récipients en verre — Bagues à crans pour bouchage sous vide —
Partie 2: 33 medium
RECTIFICATIF TECHNIQUE 1
Technical Corrigendum 1 to ISO 9100-2:2005 was prepared by the European Committee for Standardization
(CEN) Technical Committee CEN/TC 261, Packaging, in collaboration with Technical Committee ISO/TC 63,
Glass containers, in accordance with the Agreement on technical cooperation between ISO and CEN
(Vienna Agreement)
Page 2, Figure 1
Replace Figure 1 with the following figure (In the enlarged view section B-B, the arrow for footnote “c” has been moved to the right of the stop face.)
Trang 2ISO 9100-2:2005/Cor.1:2009(E)
Dimensions in millimetres
a Parting line
b See Figure 2
c The stop faces on the leads have a cap stopping function Thus they shall be sharp-edged and as perpendicular to the E-wall as possible The radii of the stop faces should be the same as of the mould A punctual replacement of moulds
is necessary to prevent worn contours
Figure 1 — Thread construction and enlarged view section B-B