Audio UnitGeneral Equipment Audio Unit Removal Tools GV3301 Removal WARNING: The supplemental restraint system SRS is active for a certain length of time after the power supply has been
Trang 1SECTION 415-01 Information and Entertainment
System
VEHICLE APPLICATION: 2011.50 Ranger
PAGE CONTENTS
REMOVAL AND INSTALLATION
415-01-2 Audio Unit
415-01-4 (33 635 0)
Bluetooth Module
415-01-5 Audio Unit Antenna
415-01-9 Navigation System Antenna
415-01-10 Front Control/Display Interface Module (FCDIM)
Trang 2Audio Unit
General Equipment
Audio Unit Removal Tools (GV3301)
Removal
WARNING: The supplemental restraint
system (SRS) is active for a certain length
of time after the power supply has been
disconnected Wait for a minimum of 3
minutes before disconnecting or removing
any SRS components.
NOTE: Removal steps in this procedure may
contain installation details
1 Refer to:Supplemental Restraint System (SRS) Health and Safety Precautions(100-00 General Information, Description and Operation)
Refer to:Battery Disconnect and Connect (414-01 Battery, Mounting and Cables, General Procedures)
Vehicles with single DIN Standard audio unit
2 General Equipment: Audio Unit Removal Tools
(GV3301)
Vehicles with double DIN Standard audio unit
Trang 34 Torque: 2 Nm 5 Torque: 3 Nm
Installation
1 To install, reverse the removal procedure.
Trang 4Bluetooth Module(33 635 0)
Removal
NOTE: Removal steps in this procedure may
contain installation details
1 Refer to:Glove Compartment(501-12
Instrument Panel and Console, Removal and
Installation)
2 Torque: 2 Nm
Installation
1 To install, reverse the removal procedure.
Trang 5Audio Unit Antenna
Removal
NOTE: Removal steps in this procedure may
contain installation details
1 On both sides.
Refer to:A-Pillar Trim Panel(501-05 Interior
Trim and Ornamentation, Removal and
Installation)
2 On both sides.
Refer to:C-Pillar Upper Trim Panel(501-05
Interior Trim and Ornamentation, Removal
and Installation)
Refer to:C-Pillar Lower Trim Panel(501-05
Interior Trim and Ornamentation, Removal
and Installation)
3.
4 NOTE: This step is not necessary when
installing a new component
5 On both sides.
Trang 66 7.
Trang 7Vehicles with autolamps and rain sensor
8.
9.
10.
All vehicles
11 CAUTION: Take extra care not to crease
the headliner.
NOTE: Make a note of the routing of the
antenna cable
12 CAUTION: Take extra care not to crease
the headliner.
NOTE: Make a note of the routing of the
antenna cable
Trang 8Installation
1 NOTE: The antenna cable must be installed to
the same routing as when removed
To install, reverse the removal procedure
Trang 9Navigation System Antenna
Removal
NOTE: Removal steps in this procedure may
contain installation details 1.
2.
Installation
Trang 10Front Control/Display Interface Module (FCDIM)
Removal
NOTE: Removal steps in this procedure may
contain installation details 1 Refer to:General Information, Description andHealth and Safety Precautions(100-00
Operation)
2 Refer to:Battery Disconnect and Connect (414-01 Battery, Mounting and Cables, General Procedures)
3.
Trang 11Installation
1 To install, reverse the removal procedure.