MÃ LỖI C1292 TRÊN XE Ô TÔ Kia Morning - P3

- THÔNG TIN MÃ LỖI - KIỂM TRA BẰNG MÁY CHẨN ĐOÁN - KIỂM TRA BẰNG SƠ ĐỒ MẠCH ĐIỆN - KIỂM TRA CẢM BIẾN

Page 1

2009 > G 1.1 SOHC > Steering > Electronic Power Steering >

omponent inspection

©) G8)ÌLangusge_~] (GÌ

Check torque sensor

1 Ignition "OFF"

2 Connect Scantool to Data Link Connector(DLC)

3 Engine "ON " and select "SCOPEMETER FUNCTION” on scantool

4 operate the steering wheel to the left and right

5 Measure output signal between terminal "2"of sensor harness connector and chassis ground

6 Measure output signal between terminal "4"of sensor harness connector and chassis ground

a Specification : [ Main sensor output - Sub sensor output ] < 0.75 mA

<M31>

oe | P 1 b 1.TSV(8V)

{|5|4|*

2.TSM(Main)

<M31>

_—Ñ

2 ly 1

*|5 14] *

2.TSM(Main)

4.TSS(Sub)

| | | 5.TSE(GND)

FR [NMMsø.su SN ENa5sv FR 8.5 U 8.5

se a8 00 dt ng in Thi ce i ict Rie Sie Dag Rin A2 zalbulisib ERR Torque sensor,

rMCOO eda

Torque sensor

2.5V(sub)

J ————— b==ez

ae _.'MTorque sensor

Wish thin th yaee ne jee Ee "mang

0V(main): : : : : : : : : : : : 0V (main)

| HOLD [zoon] | CURS | [HEMO | | RECD | [MENU] TỦ) 2001| | CURS | | HEHO | | RECD | | HENU |

Fig.1) When turning steering wheel to right : Check whether signal voltage rises to maximum 4V based on 2.5V and main sensor signal is the same as sub sensor signal [Main sensor - Sub sensor] < 0.75 mA

Fig.2) When turning steering wheel to left : Check whether signal voltage descends to maximum 1V based on 2.5V and main sensor signal is the same as sub sensor signal [Main sensor - Sub sensor] < 0.75 mA

7 Is torque sensor main and sub signal within specifications?

YES

L Substitute with a known-good EPS CM and check for proper operation

L If the problem is corrected, replace EPS CM and then go to "Verification of Vehicle Repair" procedure

m5

L Check torque sensor for contamination, deterioration, or damage

L Substitute with a known-good steering column assembly and check for proper operation

Substitiuion is necessary because torque sensor is located in steering column assembly and disconnect is impossible

http://kia-hotline.com/Main/Viewer/content.asp?IsPrint=true&vehicletype=Passenger&mfrcode=K M&area=KME&langcode= 1/4/2012 9:53:13 PM

Page 2

Lif the problem is corrected, replace steering column assembly and then go to "Verification of Vehicle Repair’ procedure

http://kia-hotline.com/Main/Viewer/content.asp?IsPrint=true&vehicletype=Passenger&mfrcode=K M&area=KME&langcode= 1/4/2012 9:53:13 PM