- THÔNG TIN MÃ LỖI - KIỂM TRA BẰNG MÁY CHẨN ĐOÁN - KIỂM TRA BẰNG SƠ ĐỒ MẠCH ĐIỆN - KIỂM TRA CẢM BIẾN
Trang 1Page 1
erminal ang Connector inspection
1 Many malfunctions in the electrical system are caused by poor harness and terminals
Faults can also be caused by interference from other electrical systems, and mechanical or chemical damage
2 Thoroughly check all connectors (and connections) for looseness, bending, corrosion, contamination, deterioration, and/or damage
3 Has a problem been found?
YES
_ Repair as necessary and then go to "Verification of Vehicle Repair" procedure
L Go to "Signal Circuit Inspection” procedure
Signal Circuit Inspection
1 Ignition "OFF"
2 Disconnect torque sensor connector and EPS CM connector
3 Measure resistance between terminal "2"of torque sensor harness connector and terminal "5"of EPS CM harness connector (Rm, Resistance value of main sensor
harness)
4 Measure resistance between terminal "4"of torque sensor harness connector and terminal "4"of EPS CM harness connector (Rs, Resistance value of sub sensor harness)
a Specification : [ Rm-Rs]< Approx + 0.80
qc *|5 m 4 + b 20|* | ~| *|16| F [+4] +] 12] «
2.TSM(Main)
4.TSS(Sub)
5 TSE(GND)
[5| 4] 3 2|
20] [+] * [16] « [5] * [12] «
2.TSM(Main)
4.TSS(Sub)
5.TSE(GND)
5 Is the resistance measured within specifications?
YES
_ Go to "Component Inspection” procedure
L Thoroughly check connectors (which measuring value is high or low) for looseness, poor connection, bending, corrosion, contamination, deterioration,or damage
L Repair or replace as necessary and then go to "Verification of Vehicle Repair" procedure
http://kia-hotline.com/Main/Viewer/content.asp?IsPrint=true&vehicletype=Passenger&mfrcode=K M&area=KME&langcode= 1/4/2012 9:52:44 PM