OptiX OSN 3500 IMAbout This Chapter This section describes how to install the fiber spool box.. 8.1Installation Position of the Fiber Spool Box Describes the appearance of the fiber spoo
Trang 1OptiX OSN 3500
Contents
8 Installing the Fiber Spool Box 1
8.1 Installation Position of the Fiber Spool Box 1 8.2 Installing the Plate and the Box 3
Trang 2Appearance of the fiber spool box 2 Top view of the plate 2 Securing the box 3
T2-0416xx- 20050330-C-1.20
Huawei Technologies Proprietary
iii
Trang 3OptiX OSN 3500 IM
About This Chapter
This section describes how to install the fiber spool box
The following table lists the contents of this chapter
8.1Installation Position of the Fiber Spool Box
Describes the appearance of the fiber spool box.
8.2Installing the Plate and the Box Describes the procedure of installing the plate
and the box.
8.1 Installation Position of the Fiber Spool Box
The fiber spool box is used to spool fiber jumpers and hold the optical attenuators
It can accommodate 4 x 10 m fiber jumpers and hold eight fixed or tunable attenuators
If the cabinet holds two OSN 3500 subracks, install the fiber spool box at the third hole from the bottom of the cabinet, more than 50 mm away from the subrack
1
Trang 48 Installing the Fiber Spool Box
OptiX OSN 3500 Installation Manual
If the cabinet holds only one OSN 3500 subrack, install the fiber spool box above the orderwire fixing frame
Figure 1.1 and Figure 1.2 show the fiber spool box
Mounting ear
Fiber hole
Plate Box
Figure 1.1 Appearance of the fiber spool box
Captive screw
fibre holder
fibre spool attenuator holder
Figure 1.2 Top view of the plate
Trang 5OptiX OSN 3500
8.2 Installing the Plate and the Box
the cabinet.
Optical attenuator
Prerequisites The cabinet and the subrack are installed.
Required/As
Step 1 Secure the box in cabinet with two panel screws See Figure 1.1
Figure 1.1 Securing the box Step 2 Fix the optical attenuators in the plate
Step 3 Spool the fibers in the plate See Chapter 10 "Installing and Routing the Fiber
Jumpers"
End