tập đoàn sản xuất máy xây dựng Kobelco đã giới thiệu mẫu xe đào – SK210. Với loại xe đào mới này, lực đào, hiệu suất máy, điều kiện làm việc cho người điều khiển cũng như độ tin cậy của m
Trang 1SK200(LC)Vi SK23010W SK320(L0)W
SK210(LC)VE SK250(LC)V SK330(LC)Wi
SK250NLCW SK330NLCVW
S
skanocent| (3 | Ss
SK210(Lc)W SK250nLcW | | SK330nNLcU
15-3 @ Warning display
No ; Only | Only Input Circuit nay key | E⁄G AI Display condition value
symbol ON | RUN (C-1)
1 | MECHTRO O O When there is no communication for 5 seconds
C-1 CPU CONT FAIL trom mechatro controller to gauge cluster
- SOL doesn’t work by the signal of controller SOL /V
2
turned to “RELEASE” position (12-18)
- PSV doesn’t work by the signal of controller 12V
3
—————— to “RELEASE” position (12-19)
4 4 E/G O While starter switch (key) is turned to “HEAT” | 24V
L
Mt ae O 25 seconds or later after the preheating started (2-18 )
When E/G oil pressure for SK200VI and SK230VI is
6
(In normal, Low 1.5/2kgt/cm? ~ Hi 5kgef/cm?)
5
9 M1 CHARGING When alternator generating voltage is 12V or less 12V
Remaining fuel level of fuel tank 16V
12
SK320M - 60L or less (14-8)
11 31-1 LOW HYD O When hydraulic aii level is low at machine oil level | Open
1á
15
SN 23 BEVEL O When engine oil !evel of E/G oil pan is low pen,
14 19 POWER ©lIO When the switch on the grip upper section of ATT | GND
15 21 fod When E/G and hydraulic oil are warmed up in
16 [aa When auto warming up has Tinished 4 “OFF
SW-38 ole FINISH O x - When hydraulic oil temperature switch (sen-
sor) is sensed temperature 10°C or more
23 CHANGE When E/G total operating time has passed
1 lane E/G OIL O O 500 hours after E/G oil change
@ E/G operation means the condition when the alternator generating voltage is 12V or more in the condi-
tion where the E/G oil pressure S/W is 5kgf/cm’
@ Buzzer sounds or not
L) : Stops sounding by pressing buzzer stop switch, X : Stops sounding automatically 5 seconds later
A : Doesn't stop sounding even if buzzer stop switch is pressed, : For blank spaces, buzzer doesn’t sound