Tài liệu CCNA Semester 1 Skills Based Final – Part 1 Cable Build / Test pptx

Test the cable with a cable tester to verify continuity, correct pinouts and cable length.. This cable can be used to connect your workstation to the hub or switch for exam part 3.. Dire

CCNA Semester 1 Skills Based Final – Part 1 Cable Build / Test

Name: _Date: _

(Total possible Points: 20)

Objective:

Build an Ethernet 10BaseT straight thru cable to connect from a workstation to a hub or switch Use UTP cable and wire all eight conductors using the correct wire colors and pins for either a T568A or

T568B Test the cable with a cable tester to verify continuity, correct pinouts and cable length This

cable can be used to connect your workstation to the hub or switch for exam part 3

Directions:

Obtain a piece of CAT 5 cable (depending on use) and two RJ45 connectors Use a crimping tool to attach the RJ 45 connectors to the cable Use a cable tester to test the cable to verify that is

functional Indicate which cabling pinout standard (T568A or T568B) you will use _

1) Are the correct wires pins in the correct position? Initial _ (10 pts) 2) Does cable test OK with cable tester? Initial _ (10 pts)

Points Scored: _

Semester 1 Skills Based Final – Part 2 Network Concepts

(Total possible Points: 30)

Objective:

Answer the 3 questions on networking concepts as assigned by the instructor Write the questions

assigned in the space provided below You may be asked to answer orally or write your answers on the back of this sheet Answers should be as detailed as possible for maximum credit

Question 1: (10 pts):

_ _

Question 2: (10 pts)

_ _ _

Question 3: (10 pts)

_ _ _

Points Scored:

Semester 1 Skills Based Final – Part 3 Network Connection

Workstation #: _

(Total possible Points: 50)

Objective:

Connect your workstation to a LAN Configure the network settings and troubleshoot as necessary

Use your web browser to connect to router interface 152.20.71.237 and display the web interface

After you have successfully connected to the router, the instructor will introduce problems into the

PC and/or network which must be resolved and documented in the space provided Include the

following: symptoms, causes, details of tests done, detailed problem results (from layer 1 testing),

detailed solutions

You will be assigned a workstation number that will become the useable subnet # with which you

will perform this assessment Make sure you have an appropriate assigned subnet number

before starting

You will be using a class C network 193.5.5.0 which is divided into subnets by borrowing 5 bits from the network portion of the address The subnet number assigned is the same usable subnet (1st, 2nd 3rd etc.) as your workstation number The proctor must initial each step as you answer the following

questions The default gateway (nearside router port) for your host is 193.5.5.1

Write the IP address of your workstation here:

1 What is the subnet mask? Initial (5 pts)

2 Subnet host IP address range? _ Initial (5 pts)

3 Network address of your subnet? Initial (5 pts)

4 Broadcast address of your subnet? _ Initial (5 pts)

5 Ping the router default gateway Initial (10 pts)

6 Open the web page at 152.20.71.237 with your browser Initial (10 pts)

7 Identify and resolve troubleshooting problems listed below Initial (10 pts)

Total points _

Troubleshooting Activity Record (use back if necessary)

Symptom / Cause Tests / Results Detailed Solutions

Points Scored: Part 1 +Part 2 _ +Part 3 _ = Total

…