Out Lines Outlines of Default parameter: • Suzuki prefers to specify the parameters below as the default: • Change the NIP from 5 to 7; • “Refining meshes” option off; • “Coarsening me
Trang 1Default Config Parameters
Auto Setup
Date: 2014,06,17
Trang 2Out Lines
Outlines of Default parameter:
• Suzuki prefers to specify the parameters below as the default:
• Change the NIP from 5 to 7;
• “Refining meshes” option off;
• “Coarsening mesh” option off in the Springback stage
Trang 3Description of New Feature
Description:
• For the Blank, the user can change the NIP from 5 to 7 This config is used for all setups
• The result is shown in the following slide
Trang 4Description of New Feature
Trang 5Description:
Trang 6Description of New Feature