1. Trang chủ
  2. » Giáo án - Bài giảng

Nghệ thuật gấp giấy_Con Chó trong nhà

4 301 0
Tài liệu được quét OCR, nội dung có thể không chính xác
Tài liệu đã được kiểm tra trùng lặp

Đang tải... (xem toàn văn)

THÔNG TIN TÀI LIỆU

Thông tin cơ bản

Tiêu đề Dog in a Doghouse
Trường học Standard University
Chuyên ngành Origami
Thể loại Hướng dẫn
Thành phố Standard City
Định dạng
Số trang 4
Dung lượng 372,5 KB

Các công cụ chuyển đổi và chỉnh sửa cho tài liệu này

Nội dung

Fold each point back to the right, incorporating the reverse fold shown into the near layer.. Fold the two near right points to the left as far as possible.. Fold up the near right edge

Trang 1

_ isontally

DOG IN A DOGHOUSE

Use a square of paper-backed foil Begin with the white side up Crease the paper in half hor-

fee on ee

1 Fold the top and bottom

edges to the horizontal

center crease

4 Fold each point back to

the right, incorporating

the reverse fold shown

into the near layer

7 Reverse-fold the left end

downward; the crease

aligns with the edges of

the flaps folded up in

step 6

2 Reverse-fold the upper and lower right corners

5 Fold the model in half lengthwise, from top to - bottom

8 Pull a single layer of paper out from the inside and wrap it upward in the front; repeat behind

i

3 Fold the two near right points to the left as far

as possible

-

-~

Ke

Lai

we

6 Fold up the near right edge so that it lies along the top edge; repeat behind

„ |

9 Fold one flap from the left over to the right

96 ORIGAMI ZOO

Trang 2

—=>

10 Mountain-fold to the rear

the top triangular

portion of the model,

along with the three

white points Turn the

model over from side to

side

<a

iv

13 Fold the left edge in to

the center line, crease,

and unfold Then fold the

top edge down to the

bottom edge, make a

small crease at the left

edge only, and unfold

<2

NON ZINA LALA

NTWYwLALS

16 Crease each of the two

pairs of angle bisectors

shown at the top and

bottom as mountain

folds (turn the paper

over and make valley

folds) Fold the bottom

edge up to the horizontal

crease and unfold

==

1

11 Enlarged view Fold the right edge in to the vertical center line, crease, and unfold

14, Fold the top and bottom edges to the short crease just made and make a sharp crease all the way across the model, being careful not to let the layers slip Unfold

YPN

= —

™ ` “i 3

\

de

17 Pleat the bottom of the model using the existing creases The model will

no longer lie flat

12 Swing the three white points to the right

XK

cv

15 Crease the four pairs of angle bisectors shown

18 Swivel the bottom edge upward on each side

DOG IN A DOGHOUSE 97

Trang 3

19 Fold the top edge down

22

and the bottom edges up

while moving the sides

inward; make two pleats,

one at the top and one at

the bottom, to take in

the excess paper Lift the

base of the three white

points toward you and

swing the points down

through the opening at

the bottom The model

remains three-

dimensional

Lio

`:

like this; the model

is fully three-

dimensional Turn the

model over from side to

side

25 Side view of the three

20 Turn the paper over from side to side

Lge

YN

23 Enlarged view; the three white points are not shown, but if they were, they would be pointing directly at you through the opening in the middle of the model

Fold the hidden flap indicated by X-ray lines over and over on the inside to lock the sides together

21 View from step 20 Pleat the back on existing creases where shown and bring the sides

together

24 Perspective view of the model thus far The colored region is the doghouse; the three white points will become the head and forelegs of the dog

white points Pleat the near and far points downward To make steps 25-33 easier, undo the lock made in step 23 and open the house somewhat; close the house when finished

26 Fold a rabbit ear from the downward-pointing flap, raising it up Swing the entire flap to the right; repeat behind

98 ORIGAMI ZOO

Trang 4

27 Bottom view of the

doghouse Spread the

layers at the tip of each

leg to form paws

30 Details of the dog’s head

Squash-fold the flap

downward, opening it

out as much as possible

33 Pull the head forward

while pushing in the top

of the head and muzzle

to flatten them and make them three-dimensional

28 Fold the tip of each paw inward to blunt it Turn the model over from top

to bottom so that it is upright

VA

31 Mountain-fold the right side behind

Ds

>>

29

32

Side view Squash-fold the remaining (middle) white point upward Note that the squash fold extends left into the doghouse

te

Fold the upper left edge down to form an ear; repeat behind Crimp the head with two reverse folds to form a muzzle; you will have to lift up the head to do this Outside-reverse-fold the tip of the nose

34 Two views of the finished Dog in a Doghouse

DOG IN A DOGHOUSE 99

Ngày đăng: 31/05/2013, 00:21

TỪ KHÓA LIÊN QUAN

w