Nghệ thuật gấp giấy_Con Kiến

Spined Ant erin Seen 19 Use foil-backed paper oor 1 Begin with the white side up 2° Fold and unfold the angle 3 _ Fold and unfold Fold and unfold the diagonals bisectors, Tum the paper

Spined Ant erin Seen 19

Use foil-backed paper

oor

1 Begin with the white side up 2° Fold and unfold the angle 3 _ Fold and unfold

Fold and unfold the diagonals bisectors, Tum the paper over

hisectors through both layers Unfold to step 7

10 Fold and unfold the angle 11 Enlarged view Make the two Í2 Colapse on excisting

bisectats through both layers vertical mountain-folds and then creases, Next step shows

the triangles (see next step)

o>

#12)

os

16 Fold the flap at the back 17 Swivelfold, Repeat on the 18 Like this Closed-sink the

dawn as far as it will go right, thus being able to lower triangle upward

Rotate the madel squash flat (see next step)

R<O DY

19 Repeat steps 17-18 20 Fold the upper flap down 21 Enlarged view of the center flap

in thirds Then unfold to step 20

22 Repeat steps 20-21 23 Valley-fold one edge dawn 24: Fold the right fap

on the angle bisector on the top left

Then refald to step 24.

28 Fold over and over

31 Valley-fold

34 Valley-fold

29 Repeat steps 23-28

below

32 Valley-fold

35 Fold in the edges as the

large flap is folded down See next step

30 Mountain-fold in hait

Rotate

33> swivel fold

36 in mic-air Swivelfold

Continue folding the flap down,

&

1⁄4

Yvvyẻ$

37 Tum the model over 38 Valley-fold 39 Unfold the petal fold

40 Fold and unfold AT squeeze the sides together 42 Reverse-fald

and swing the bottom flan over to the lef See

next step

43> Valiey-fold the center flap AA Fold and unfold 45 Open sink

to the right, and repeat step

42 on the left side.

416 Detail of sink Repeat 47 Fold and uniald the 8 Fold and unfold the

left side

in and out

52 Reverse-fold two edges 53 cut-away view Reverse-fold 5A Repeat steps 51-53 on the

The valley fold is on the the right flap is unfolded crease made in step 52 during the process

55> Enlarged view of the head 56 Lif the flap upward 57 Pleat-old, The divisions,

Reverse-fold the antennae ‘without pressing fat using the edge behind,

‘will ga

side

and squash fat sa that they point straight

‘out toward you,

WY

Collapsing on the creases made

64 Lit the tap atthe back 65 The back-boty isnot shown 66 in stop 21, put the twa edges

and fold the head to the ‘Squash the thick edge flat inside the nearest pockets

from top of back-body, and fold comer a over to Fold the edge inside

the right The body becomes:

3-dimensional

70 Detail of head 71 squashold 72 Petavioid

Push in where indicated, Press the

jaws together and fold the resulting

edge to the left at the back-side

Next view fram behind the jaws

eof

73 Collapse to make a paint 74 The head is now 3-D 75 Pinch between the head and

straight backward

76 Pinch points a, b and c 77 Pinch the twa front pairs of legs 78 The finished Spined Ant

Paint c should be slightly with mountain folds, and the third

and form the legs to make feet ete

Side view.