Bone marrow derived mesenchymal stem cell (BM MSC) application in articular cartilage repair 3

Trypan blue viability test of the labeled and unlabeled MSCs showed a significant decrease in high labeling concentration 100 and 125 µg/mL... To evaluate the effect of the ferucarbotran

Figure 3-7 Trypan blue viability test

Trypan blue viability test of the labeled and unlabeled MSCs showed a

significant decrease in high labeling concentration (100 and 125 µg/mL)

75

80

85

90

95

100

Labeling medium iron concentration (µg/ml)

Figure 3-8 MTS assay

MTS assay showed that labeling of the MSCs did not affect the proliferation rate of the cells over time

3.4.6 Differentiation potential of labeled MSC

MSCs are multipotent stem cells, which can differentiate to different lineage (77, 78, 198, 199) To evaluate the effect of the ferucarbotran labeling on the multipotent potential, we assessed the adipogenic (figure 3.9), osteogenic (figure 3.10), and chondrogenic (figure 3.11) differentiation capacity of the labeled cells

3.4.6.1 Adipogenic differentiation

Qualitative evaluation of adipogenic differentiation after 21 days by Oil red O staining demonstrated that unlabeled and labeled cells exhibited no difference

in developing fat vacuoles (Figure 3.9)

Figure 3-9 Oil red O staining

Oil red O staining of the MSCs after 21 days adipogenic differentiation

induction; Unlabeled (A), labeled with 25 µg/ml ferucarbotran (B), labeled with

50 µg/ml ferucarbotran (C), labeled with 75 µg/ml ferucarbotran (D), labeled with 100 µg/ml ferucarbotran (E), labeled with 125 µg/ml ferucarbotran (F)

3.4.6.2 Osteogenic differentiation

Alizarin red staining showed that MSCs labeled with SPIO did not affect osteogenic differentiation capacity of cells (figure 3.10)

Figure 3-10 Alizarin Red staining

Alizarin Red staining of the MSCs was used to visualize the calcium

deposition of the cells after 21 days osteogenic differentiation induction; Unlabeled (A), labeled with 25 µg/ml ferucarbotran (B), labeled with 50 µg/ml ferucarbotran (C), labeled with 75 µg/ml ferucarbotran (D), labeled with 100

3.4.6.3 Chondrogenic differentiation

Immunohistochemical staining after high density pellet culturing showed that the distribution of collagen type II in extracellular matrix of cells was same between unlabeled and 25 and 50 µg/mL SPIO labeling, however the matrix production were decreased in labeling concentration of higher than 75 µg/mL SPIO (Figure 3.11) Alcian blue staining also showed the inhibition of the Aggrecan production in labeling concentration of the 75 µg/mL or higher Prussian blue was used to show the presence of iron particles

Interestingly, SPIO labeled MSCs separated into distinct areas; the areas with less Prussian blue stains (less iron content) showed more collagen type II and aggrecan production It appears that the inhibition seemed to be related to the cellular iron content, increasing the labeling concentration could inhibit

chondrogenesis

Figure 3-11 Chondrogenic differentiation potential evaluation of the MSCs

Upper panel shows the Alcian blue staining of unlabeled and labeled cells with different concentration of ferucarbotran (25µg/mL, 50µg/mL, 75µg/mL, 100µg/mL, 125µg/mL) Middle panel shows the immunohistochemistry against collagen type

II in all groups and lower panel demonstrate the Prussian blue staining of the cell pellets to visualize the iron particles as blue dots in the cells (Scale bar is equal to 100 µm)

3.4.7 MR imaging of animals

3.4.7.1 Preliminary experiments

To optimize the sequences that we needed to visualize the articular cartilage

of the pig knee, we performed a trial MRI to test different coils and sequences

on the pigs’ normal knee Figure 3.12 showed chondral defect without / with different fillings Blank defect was the defect with no filling (air), which made a signal loss (dark defect) in both FSE and GRE sequences Defect with

scaffold only (1% agarose) filling showed an iso-intense signal to adjacent cartilage in both FSE and GRE sequences Defects filled with the agarose mixed with different amount of Ferucarbotran, which can be a representative

of different concentrations of the labeled cells (the average amount of the iron nanoparticles per cell was assumed as 10ng/cell; e.g 1, 10, 1000 µg iron nanoparticles were mixed with agarose as representative of 100, 1000,

100000 cells) We showed the efficacy of specifically imaging proton density (short TE FSE) for anatomical data and the sensitivity of gradient echo

sequences (SPGR and 2D/3D-GRE) to signal loss due to iron nanoparticles to reveal contrast between newly formed tissue and the incorporated iron

nanoparticles (Fe) The FIESTA sequence was also useful in the context of proton density, however FIESTA images with Fe injected into the knee space (to simulate unattached labeled cells) contained artifacts, which could

interfere with interpretation

Figure 3-12 MR imaging of the Pig's knee explant

MR images of the pig’s knee explants with blank and scaffold only defect (A), 100 cells simulation (B), 1000 cells simulation (C), and 100,000 cells simulation (D) Left panel of each image is 3D-FSE sequence and Right panel is 3D SPGR sequence