Quản trị mạng CCNP.Sem9.Security

Quản trị mạng

Nguyen Khac Quyet - Take Exam

Exam questions

Time remaining: 00: 48: 25

1 Which of the following four (out of a total of nine) RFC 1757 RMON groups are supported by Cisco switches?

Statistics Group

History Group

Logging Group

Social Group

Alarm Group

Event Group

2 Which two are characteristics of extended access lists?

May filter traffic based on the protocol type

May filter traffic based only on the source address

May not filter traffic based on the source address

May filter traffic based on the destination address

3 TACACS+ uses which of the following protocols to communicate ?

UDP

CDP

TCP

DES

4 What are two switches that support redundant supervisor engines?

4000

5500

6000

12000

5 When using access lists, what does a Cisco router check first?

The packet contents

The destination address

The source address

To see if the packet is routable or bridgeable

6 Which of the following provides a GUI-based management interface for Cisco switches?

VlanDirector

TrafficDirector

CRM

CSWI

7 Access lists are numbered Which of the following ranges could be used for an IP access list? Choose two

600-699

100-199

1-99

800-899

1000-1099

8 What are the two things you must do to activate an access list?

Set up the access list with the command and parameters

First shutdown the interface that the access list will be applied to

Apply the access list as part of a group on an interface

Use the access-list command to apply the access list to the interface

9 What is the purpose of Switched Port Analyzer (SPAN) on a Catalyst 5000?

Shows the module of where the SPAN port is located

Shows the module of where the VLAN identifier is located

The VLAN that is providing the source frames duplicates the frames

The flow of data from a source and destination port is mirrored to the port designated at the SPAN port using a Protocol Analyzer

10 Read and answer the question

A

B

C

D

11 What feature must you have to access additional RMON groups?

Spanning Tree

SPAN

RMON8

CWSI

12 Which statement describes a feature of a Switch Port Analyzer (SPAN) session?

Affects switching traffic on source ports

Associates a source interface with multiple destination interfaces

Eliminates multiple copies of packets

Associates multiple source interfaces with a single destination interface

13 What are the two types of access lists that can be configured on a Cisco router? Choose two

Standard

Packet

Filtering

Extended

14 Which of the following is a characteristic of port security?

Port security is meant to be configured on trunk ports

Limits the MAC addresses that are allowed to use the switch to prevent unauthorized users from gaining access to the network

When using EtherChannels, it is highly recommended that you do not disable port security

Port security limits the IP addresses that are allowed to use the switch

15 What applications are included with CWSI (CiscoWorks for Switched Internetworks)? Choose five

CiscoView

CLI

VLANDirector

Traffic Director

STP

ATMDirector

ResourceManager

TACACS+

16 Which Cisco management product would you choose to manage Cisco switches?

TrafficDirector

CWSI

MRTG

Scion

17 In order to limit the quantity of numbers that a system administrator has to enter on an access-list, Cisco can use which

abbreviation to indicate 0.0.0.0?

host

any

all

include

18 When using a Switched Port Analyzer (SPAN) on a Catalyst 5000, what is identified by the destination module (port identifier)?

The module of where the SPAN port is located

The module of where the VLAN identifier is located

The VLAN that is providing the source frames

The source and destination trunk port

19 Read and answer the question

A

B

C

D

20 What four groups in the RMON specification (RFC 1757) does the Catalyst 5000 embedded RMON agent support?

Statistics Group

Supervisor Group

History Group

Alarms Group

Events Group

Showing page 1 of 1 : 1 Go!

© 2004 HanoiCTT All rights reserved