M08.02: PA 49Tablettentest Das Pressen der Tablette: Wir verwenden eine hydraulische Presse der Firma Perkin & Elmer.. 0,75 g des zu prüfenden Pulverlackes werden in einem Preßstempel
Trang 1M08.02: PA 49
Tablettentest
Das Pressen der Tablette:
Wir verwenden eine hydraulische Presse der Firma Perkin & Elmer
0,75 g des zu prüfenden Pulverlackes werden in einem Preßstempel bei einem Druck von 40 bar und einer Zeitdauer von 5 Sekunden zu einer Tablette verpreßt
Tabletten-Test:
Ein Aluminiumblech (0,7 mm dick) wird auf die eigens angefertigte Metallvorrichtung gegeben und die eben gepreßte Tablette auf das Glas gelegt ⇒ Abb 1
Diese Anordnung stellt man für 60 sec in einen Ofen und läßt die Tablette angelieren damit
eine Haftung zum Aluminium besteht
Die Metallvorrichtung wird auf eine Seite gedreht, damit die Schmelze nun in einem Winkel von 45° abrinnen kann ⇒ Abb 2
Als Prüfparameter sind 10 Minuten bei einer Temperatur von 180 °C festgelegt
Zugelassen von Ausgabedatum Änderungsstand Seite
Aluminiumblech Pulvertablette
Gestell
45 ° Winkel angelierte Pulvertablette
Erkenntnisse:
Die zurückgelegte Abrinnstrecke der Schmelze in [ mm ] ist ein vereinfachtes Maß für die Viskosität des zu prüfenden Pulverlacks
Je kürzer die Abrinnstrecke, umso höher die Viskosität des Pulverlackes und umgekehrt, je länger die Abrinnstrecke umso niedriger ist die Viskosität
Eine hohe Viskosität führt zu einer feineren Grobstruktur , eine niedrige Viskosität führt zu einer flacheren Grobstruktur
Pressing the tablet: We use a hydraulic press of the company Perkin & Elmer 0.75 g of
Trang 2M08.02: PA 49
Tablettentest
Zugelassen von Ausgabedatum Änderungsstand Seite
the powder coating which can be checked are injected in a press stamp with a printing by
40 bar and a length of time from 5 seconds to a tablet Tablet test: An aluminum plate (0.7 mm thickly) is given on the especially made metal device and the evenly pressed tablet on the glass is put  Abb 1 this arrangement one provides for 60 seconds into a furnace and leaves fixed to the tablet thereby an adhesion to aluminum exists The metal device is turned on a page, so that the melt can flow off now in an angle of 45°
 Abb 2 as test parameters is 10 minutes at a temperature of 180 °C determined Abb 1 fig 2 realizations: The put back flow off distance of the melt in [ mm ] is a
simplified measure for the viscosity of the powder coating which can be checked The more briefly the flow off distance, the more highly the viscosity of the powder coating and in reverse, the longer the flow off distance the lower is the viscosity A high
viscosity leads a low viscosity to a finer basic structure, leads to a flatter basic structure