Tài liệu lilyfly_2 ppt

Do the star precrease, color side up, and collapse the model into a colored preliminary fold.. Fold and unfold to the center line.. Inside reverse fold along the precreased lines.. Fold

by Kalei Anne Lundberg copyright 2000 This model appeared while I was playing with the lily base and because I wanted

to send a butterfly to Sweden The diagrams are offered for personal use any other

use please contact me for permission at lilyfly@kalei.com

1 Do the star precrease, color

side up, and collapse the model

into a colored preliminary fold

2 Fold and unfold to the center line Repeat on the other side

3 Inside reverse fold along the precreased lines Repeat on the other side

4 Fold and unfold to

the center line Spread

squash fold along the

precrease

5 Model after the spread squash is complete

Repeat on the other 3 sides Note this is the lily base with the small points tucked to the inside

6 Fold a single layer on the front and back left side to the right Note:

that the right side of the model will now enclose two full points

7 Valley fold the top point down This fold will fall along the interior thickness

10 Petal fold.

11 Tuck the small point to the

inside

12 Turn model over 13 Valley fold the top layer to

the left to complete the separation between the two bottom wings

14 Fold model in half

9 Inside reverse the two triangular folds between the top and bottom set of wings

Squash fold the bottom triangular fold

8 Open up the four

points The model will lay

flat Note: The reverse

side of the model should

be oriented as in step 13

15 Fold and unfold to align along the edge of the wings

16 Outside reverse along the precrease line while sliding the point downward This will cause a small crimp fold on either side of the model

17 Note that the

crimp curls up over

the top wing and

tucks into the body

18 Fold and unfold

Light lines show the landmark Repeat on back

19 Reverse fold the tips

to the inside The bottom wings have an extra reverse fold for the tip

Repeat on back

20 Reverse fold the small tip between the wings along line Repeat on the back Fold wings to the right repeat on the back

21 Step reverse fold the

tip three times Note the

second reverse will be

even with the body side of

the model Open

22 Shape the wings by sinking the tips through all layers Some

of these can be a bit tricky

23 Ta Dah!!!!