Nghệ thuật xếp hình Nhật Bản:pumpkin_2

Fold and unfold to set the crease for the stem section.. Inside reverse fold to the crease line made in step 3.. Petal fold the bottom portion of the squash fold while opening the top po

by Kalei Anne Lundberg copyright 2000 This model is named for my sister-in-law, who is a firm believer that there can never be too many Halloween decorations It is best made of duo-colored paper, but I have tested the design by using restickable glue stick to tack the outer edges of the eye color paper to orange tissue paper There is some minor slippage in the swivel fold in step 8 along the eye side of the fold A six inch piece of kami will make a model about 2.5 inches tall without the stem The diagrams are offered for personal use For any other use please contact me for permission

at pumpkin@kalei.com

Pumpkin page 1 of 3 http://www.kalei.com

1 Eye Color Up Crease the

center line

2 Valley fold to the center These folds should be make to butt very tightly together

3 Fold and unfold to set the crease for the stem section

4 Valley fold to center These folds

could even overlap a little Unfold

left side

without the stem section of the model

Pumpkin page 2 of 3 http://www.kalei.com

7 Swivel fold to form nose and

narrow eyes

8 Valley fold Repeat steps 5-8 on the right side flap

9 Inside reverse fold to the crease line made in step 3

10 Valley fold The top edge

should be parallel to the upper

edge

11 Squash fold 12 Petal fold the bottom portion of the

squash fold while opening the top portion to lay flat

13 Completed fold Repeat on

the other side

14 Valley fold flap through the jaw folds

15 Tuck the top portion of the lower mouth flap behind the eye flaps Fold tip under

16 Mountain fold the tip

along the crease made in

step 3 Turn model over

17 Open up the stem section and squash fold

18 Valley fold the tip down Valley fold the sides to the center

19 Squash fold the

corners

Pumpkin page 3 of 3 http://www.kalei.com

22 Yet another rabbit ear

Accordion pleat the sides to the

center and fold flat at a slight

angle

23 Tuck inside the pocket

Twist the stem to position and make it 3 dimensional

BOO!

20 Rabbit ear the sides The center fold of the rabbit ear will lay even with where the jaw flap meets the eye flap

on the front side This fold need not be flattened as it will be rolled back outward

in the next step

21 Valley fold outward Pinch along the edge using your thumbnail while rolling the paper outward The center fold

of the rabbit ear should pleat upwards Turn model over