Moldflow 2 Part 9 doc

8.10 Angular Pin Create an angular pin with holes through the relevant plates according to the "Oversize" values.. 8.11 Cap Screw Create a cap screw and cap screw holes through the relev

8.10 Angular Pin

Create an angular pin with hole(s) through the relevant plates according to the

"Oversize" values Press to see the parameter scheme

Parameters

• *D1 - Pin diameter

• D2 - Pin shoulder diameter

• D3 - Pin head diameter

• K - Head length

• A - Head angle (and Pin angle)

8.11 Cap Screw

Create a cap screw and cap screw hole(s) through the relevant plates

according to the "Oversize" values Press to see the parameter scheme

Pa am use the scroll bar on th

ha d s ccess the missing para

ter

D2 - Shoulder diameter

• K - Shoulder length

• Tap - Tap length

• DP - Depth of tapping preparation

drill (affects the hole only)

• S1 - Screw length

• SW - Size of hexagon hole

• B - Actual thread length

• *D1 - Screw diame

•

• D3 - Diameter of tapping

preparation drill

• Gap - Safety gap

The Through Thread check box will cause the hole to be a through hole on

the final part

w 8.12 Countersunk Scre

Create a countersunk screw and countersunk screw hole(s) through the

relevant plates according to the "Oversize" values

Parameters - use the scroll bar on the

right-hand side to access the missing parameters

• *D1 - Screw diameter

n

h

gth

h of tapping preparation

ad length

• D2 - Head diameter

• D3 - Diameter of tapping preparatio

drill

• K - Shoulder lengt

• Tap - Tap len

• DP - Dept

drill

• SW - Size of hexagon hole

• B - Actual thre

• Gap - Safety gap

A - Socket head angle

hrough hole on

•

The Through Thread check box will cause the hole to be a t

the final part

8.13 Shoulder Screw

Create a shoulder screw and shoulder screw hole(s) through the relevant

plates according to the "Oversize" values Press to see the parameter scheme

has the parameter Hole Type:

1:

This dialogue

Hole Type Through hole

Parameters - use the scroll bar on the

right-hand side to access the missing parameters

• *M - Screw diameter

• d - Screw body diameter

• D - Head diameter

• K - Head Depth

• t - Hole extension from top of head

• S - Movement distance

• T - Thread length

• Tap - Tap depth

ia eter of taping preparation drill

• SW - Size of hexagon hole

The other two types have the same parameters but the hole does not go

through the top plate

ll use the h hole on the final part

• Dp - Depth of tapping preparation drill

• L - Screw length

Hole Type 3: Blind countersunk hole Hole Type 2: Blind drill hole

The Through Thread check box

wi ca hole to be a throug

8.14 Set Screw

Create a set screw and set screw hole(s) through the relevant plates

according to the "Oversize" values Press to see the parameter scheme

Parameters

•

•

•

•

*D1 - Screw diameter

D3 - Hole diameter

SW - Key diameter

L - Length

Click this icon to access the ejector lock dialogue (refer to Ejector Locks)

Click this icon to acce the ejector lock dialogue (refer to Ejector Locks) ss