Exxhange SQL And IIS- P20 ppsx

Figure 2.28 The Finalize Deployment TabFinalizing Deployment of Exchange Server 2007 When you launch the Exchange Management Console for the fi rst time, the Microsoft Exchange node wil

Figure 2.28 The Finalize Deployment Tab

Finalizing Deployment of

Exchange Server 2007

When you launch the Exchange Management Console for the fi rst time, the Microsoft Exchange node will be selected Under this node you’ll fi nd two new tabs: Finalize Deployment and

End-to-End Scenario The Finalize Deployment tab provides a list of recommended tasks you should perform (depending on the server roles installed on the server) to fi nalize the deployment of your Exchange 2007 server (see Figure 2.28)

The tasks listed under this tab are applied to features that are enabled by default and need

additional confi guration We highly recommend that you follow each task carefully so as not to

overlook anything However, don’t rely 100 percent on this list; these are just Microsoft’s attempt

to show you the most basic confi guration settings Your environment could require additional

confi guration forethought and planning

The End-to-End Scenario tab (see Figure 2.29) provides a list of tasks that are optional, but it’s

a good idea to review and complete them anyway

Figure 2.29 The End-to-End Tab

Adding and Removing Exchange 2007

Server Roles

After you have installed one or more Exchange 2007 server roles on a server, you have the option of adding roles later as required This can be done using the GUI or command-line interface (CLI) Adding a server role using the GUI is done by following these steps:

1 Log on to the respective server with an account that has Exchange Organization

Administrator rights

2 Open the Control Panel

3 Click Add or Remove Programs

4 Select Microsoft Exchange Server 2007

5 Click the Change button (see Figure 2.30)

Figure 2.30 Adding a Role to an Exchange 2007 Server

6 In the Exchange Server 2007 Setup Wizard , click Next (see Figure 2.31).

Figure 2.31 Exchange Server 2007 Setup in Maintenance Mode

Figure 2.32 Selecting the Server Role to Be Added to the Exchange 2007 Server

8 When the Exchange Server 2007 Setup Wizard has installed the respective roles,

click Finish.

To add one or more roles via the CLI, you need to use ExSetup.exe and not Setup.exe, as you might have thought ExSetup.exe can be found in the C:\Program Files\Microsoft\Exchange Server\ Bin folder To add a role, perform the following steps:

1 Log on to the respective server using an account that has Exchange Organization

Administrator rights

7 Now tick the roles you want to install on the server, then click Next (see Figure 2.32).