ATM LANE On Router: Interface Atm pvc Atm pvc LECS Lane database my_ database Name elanl server-atm-address 47.000...
Trang 1ATM LANE
On Router:
Interface
Atm pvc
Atm pvc
LECS
Lane database my_ database
Name elanl server-atm-address 47.000
Name élan2 server-atm-address 47.000 <-
! start LECS
interface atm 0
lane config my databse
lane config auto-config-atm-address
Start LES/BUS:
Interface atm 0.1 multipoint
Lane server-bus Ethernet élanl
Start LEC:
Interface atm 0.2 multipoint
Lane client Ethernet elanl
atm 0
1 0 5 gsaal
20 16 ilmi
(check def) LES addres
Show lane default
Show atm arp Debug atm
Show Show Show Show Show Show Show
lane lane lane lane lane lane lane
<- very important arp
client
server config
database bus
le-arp
interface
LES) LECS) LECS)
(for (for (on
Additional Commands
On LANE module:
Exact same configs as on a router, except for LEC:
Interface atm 0.1 multipoint
Lance client Ethernet 1 elanl
Maps the vlan 1 to elanl! Then can use scO in vlanl
On 1010, to point to the LECS through well known:
Atm lecs-address-default 47.000
On LECS, if want to use a different address,
Lane config fixed-atm-address
use?
Spot The Issue
When using “lane config auto-config-atm-address”
in the LECS definition, this assumes that the
1010 switch is providing the LECS’ address
through the “well known NSAP address” On the
1010, use “atm lecs-address-default 47.000 % and
point to the nsap address of the LECS router
Use “show lane default” on the router and cut and
paste!!
Blan names are CASE SENSITIVE
The selector byte is the number of the sub-
interface on which the service resides In HEX!!
Notes
If possible (allowed) put all Lane services
on the same router instead of spreading it You MUST put the services under sub- interfaces except for LECS
Write down the sub-interface # because it matters with the NSAP address of services when mapping them Check “show lane default”
to see the default nsap addresses with ** The value of the selector byte corresponds to the sub-interface number of the atm interface
the LECS
k*
Notice that in “show lane default”, address is 00 while all others are This is because the LECS goes on the major interface, while all others go on the sub interface