11  parsing json using the jackson parser

... THE INTRODUCTION - presents the rationale for the study, the aims to which the study is conducted, the research questions, the scope, the significance of the study, the research method and the ... revealed The aims and the significances of the study are also stated The final section will present the scope of the study which shows the number of participants, the time of the intervention and the ... study as well as the gaps in the field which inspire the writer to conduct the research Chapter II: Methodology - describes the research method, the participants, the textbook, and the method to...

Ngày tải lên: 20/08/2020, 14:23

... place the screw through the hole from the inside of the bracket It helps if you have a small screwdriver to hold the screw in place Then the plastic nuts are chased down on the screws from the outside of the bracket (see Fig ... Diagram of top and bottom mounting holes in the A and B brackets Figure 12.5 A bracket with binding screw Trang 2removed from the servomotor To secure the screws at the bottom two positionsof the servomotor, place the screw through the hole from the inside of the ... Attach a ser­ vomotor to the A portion of the bracket; this will be the wrist servomotor The wrist servomotor motor is attached to the gripper first Remove the servomotor horn from the servomotor, if you haven’t done so already,...

Ngày tải lên: 10/08/2014, 04:22

... the the great pyramid of Giza - The ways to construct the pyramid and the theories - Some typical scenic features of the The great pyramid of Giza - Knowing the knowledge of other wonders of the ... that they couldn’t understand well the lesson such as how toconstruct the pyramid, the reason why the pyzamid was built From the abovereasons, I decided to raise the sudents’ awareness by using the ... the Giza Plateau on the west bank of the River Nile Also in the area is the museum housing the mysterious Sun Boat, only discovered in 1954 near the south side of the pyramid The boat is believed...

Ngày tải lên: 28/10/2019, 19:04

... their needs callfor The instructor must know the needs of the students The class time may be used to more fully develop the subject matter in a way that meets the needs of thestudents Learning ... by analyzing each part of the word so that you can not only learn about the surface meaning but also the deeper connotation of the word Example –ard used in forming the personal nouns often ... compounds which have been formed in the same way as the wordoutwit is formed This kind of formation is very accurate in depicting thecondition of the defeated Germany then “Germany was outwitted, outprepared,outgeneralled,...

Ngày tải lên: 28/10/2019, 19:04

... Parsing JSON using the Jackson Parser Parsing an XML document using the DOM API Parsing an XML document using an XmlPullParser Accessing data from a file shipped with the App rather than in the ... Next button and the Finish button at the end of the installation If you left the Start SDK Manager checkbox ticked then the SDK Manager will run Otherwise select SDK Manager from the Android SDK ... monitoring select the Proceed button, otherwise remove the tick on the check box and then select Proceed In the SDK Location box enter the location selected in step three (or use the Browse button...

Ngày tải lên: 03/05/2014, 20:40

... Selected Technologies The term “solution” in this course refers to the synthesis of all of these elements, the broad categories for those things the team needs to be successful during the deploying phase ... stakeholders apprised of the progress of the deployment and how the solution will affect them „ Installation processes are the steps performed to install, and at times uninstall, the selected technologies ... direction „ The planning phase is the period during which the team and the customer define what will be built and deployed as well as how and when The planning phase culminates in the project...

Ngày tải lên: 10/12/2013, 17:15

... I speak to…? ? Giving further details It’s in connection with It’s about ? Explaining the purpose of the call I’m calling to ask about I’m phoning to let you know the details of I’m ringing ... look forward to meeting you next week, then Well, I look forward to receiving the contract by fax, then Well, I look forward to hearing from you later today, then ? Thanking Well, thank you very ... yourself when you pick up the phone Paul Anka Paul Anka speaking Hello, Coco-Cola Company ? Helping the caller Can I help you? Who would you like to speak to? ? Asking for the caller’s identification...

Ngày tải lên: 02/08/2014, 07:20

... through the screen and into the pipe Pressure in the water pocket causes the water level to pass through the screen and up the pipe The water level will typically stop before it reaches the top of the ... the shaft The impeller resembles a wheel of curved blades that rotates around the shaft, spinning liquid from the eye (center of the pump) to the outer casing of the pump This liquid enters the ... extends through the elbow and into the process flow A propeller is located on the process end of the driveshaft The propeller is sized to fit the inside diameter of the pipe The blading is engineered...

Ngày tải lên: 16/08/2013, 15:29

... Model The volunteer incorporates the feedback and repeats the activity The judges rate the activity again The volunteer incorporates the feedback and, for the third and last time, repeats the activity ... to give the activity a 10 rating The volunteer incorporates the feedback and repeats the activity The judges rate the activity again The volunteer incorporates the feedback, and for the third ... successive phase of the project places the team further away from the intimate knowledge of the customer’s needs that was gathered early in the project Large or complex projects that follow the waterfall...

Ngày tải lên: 17/01/2014, 09:20

... t On the other hand the variance of the current across the origin is proportional to |x|S(x, t) (1.1) x Therefore, Johansson’s result on the variance of the current can be interpreted as the spreading ... occupied Otherwise the jump is suppressed and the process starts again The jump rate is assumed to be asymmetric so that in general there is net drift of the system The simplicity of the model ... ourselves to the case where the jump is symmetric in the y axis but totally asymmetric in the x axis; i.e., only the jump to the right is allowed on the x axis Our results hold for other jump rates...

Ngày tải lên: 22/03/2014, 16:20

... conditions, no baffle is in either the head or the return end of the unit The tube-side fluid enters one end of the exchanger and leaves from the opposite end In general, these baffles are not as ... through the length of the exchanger This is not the case for segmental baffles The disc and the doughnut are cut from the same circular plate and are placed alternately along the length of the tube ... larger than the outside diameter of the tube (see Figure 10-19) The clean fluid (and it must be very clean) passes through the annulus between the outside of the tube and the drilled hole in the baffle...

Ngày tải lên: 02/04/2014, 16:02

... présente publication The attention of readers is drawn to the inside of the back cover, which lists other I E C publications issued by the Technical Committee which has prepared the present publication ... an international consensus of opinion on the subjects dealt with 2) They have the form of recommendations for international use and they are accepted by the National Committees in that sense 3) ... order to promote international unification, the IEC expresses the wish that all National Committees should adopt the text of the IEC recommendation for their national rules in so far as national...

Ngày tải lên: 04/04/2014, 14:50

... evaluating its machine shop’s current layout The figure below shows the current layout and the table shows the closeness matrix for the facility measured as the number of trips per day between department ... plan for the Office of Budget Management that locates departments with the greatest interaction as close to each other as possible Example 3.1 How much better is the proposed block than the current ... current block plan? The following table lists pairs of departments that have a nonzero closeness factor and the rectilinear distances between departments for both the current plan and the proposed plan...

Ngày tải lên: 04/06/2014, 14:40

... different points of the column Due to the thermal effects and the steepness of the CO2 isotherm on zeolite 13X, it was concluded that using a similar PSA cycle, if the temperature of the biogas stream ... since they help to improve the recovery of the light product, they reduce the amount of gas lost in the blowdown step and as a direct consequence, the purity of the CO2-rich stream obtained in the ... seeded in the same land one out of five years Only the seeds are extracted whereas the rest of the plant is crushed while gathering the seed and left on the fields to be rot Doing so, the soil...

Ngày tải lên: 19/06/2014, 14:20

... further confirming the above results that the incorporation of trimethylsilyl groups into the polymeric backbone decreases the interactions between the pyrene units On the other hand, the band around ... associated with the distortion of the polymer The exciton energy decreases when the size of the excited area increases, but the Coulomb attraction in the electron-hole pair (EHP) can confine the exciton ... through the polymer chain in the opposite directions because of the applied voltage; getting closer they start to attract each other until they occur at the neighboring blocks A2 and A3 (Fig 1, b) The...

Ngày tải lên: 19/06/2014, 21:20

... two The larger block has four coupled tasks while the other has three We consider the former as the major block and the latter as the minor block The relationships in the new arrangement of the ... of the work done in the previous step The relationships among the tasks not change in time In this Chapter, we accept the aforementioned assumptions as the basis of the work; however, from a theoretical ... information into the design process In this chapter we concentrate on the first type The very existence of iterations in the design process is the primary source of the increase in the development...

Ngày tải lên: 20/06/2014, 11:20