Cat 5000 series switch
Set
Set
Set
int scO up
int scO <vlan> 10.1.1.1 255.255.255.0 10.1.1.255
ip route 0.0.0.0 146.84.131.254
Set trunk 5/4 on 1-1005 isl
Set
Set
Set
vmps tftoserver A.B.C.D
vmps state enable
port membership 5/7 dynamic|static
Set port broadcast 5/7 50%
set
Set
Set
vtp domain Tivoli-indy
vtp mode transparent|server|client
Show cam dynamic Show system Show module Show vlan Show spantree 5/7 Show trunk 5/7 Show port security 3/4 Show port broadcast Clear port broadcast 3/4 <- removes restrictions Show ip permit
Additional Commands
clears any static cam entries for that port
You can add a mac address to the port:
Set the max number of macs on port:
Set port security 2/4 maximum 3
Clear port security 3/4 [mac]all1]
To set security violation action:
But remains active
To set the shutdown time:
set port security 3/4 shutdown
QO disab]
[10-1440 min, O disal]
Set port broadcast 3/4 75% <- bandwidth based
Broadcast-based will filter all broadcasts for
threshold for remainder of the 1 sec interval
Set ip permit enable Set ip permit 10.1.0.0 255.255.0.0 Set ip permit 20.1.1.1 255.255.255.255 <- adds Set snmp trap enable ippermit
Clear ip permit {ip + mask|all]
Set ip permit disable
UDLD (must be enabled on both sides)
Show udld port 3/4
Spot The Issue
e If the scenario calls for “vlan A”, make sure
you use “set vlan 50 name VLAN A”
enabled too
stuff like: type, state, mtu, said, bridge,
lights across the board
a “set trunk 2/9 on 1,4 isl”
instead of
trunk 2/9”
there, otherwise that whole command is
removed on reload or end console session
Notes
Use “session” to get to the ATM lane card or RSM Trunking on a 4000:
Use interface Ethernet 0.1 Encapsulation isl <vlan #>
Ip address A.B.C.D 255.255.255.0 Int e 0.2
Encapsulation isl XX
Ip address 10.1.1.1 255.255.255.0