APPLETALK Appletalk routing Ị Apoletalk routing eigrp 10 Appletalk route-redistribution.
Trang 1APPLETALK
Appletalk routing
Ị
Apoletalk routing eigrp 10
Appletalk route-redistribution <- don't forget!!!
Ị
interface ethernet 0
appletalk cable-range 10-20 10.1
Appletalk zone Admin
Appletalk zone Marketing
Appletalk protocol eigrp
No appletalk protocol rtmp
Ị
On NBMA HUBS!!!
Appletalk local-routing
Interface serial 0
no appletalk eigro-spplithorizon
no appletalk rtmp-splithorizon
<- specify node!
Show apple route Show apple interface s 0 <- most important command Debug apple routing
Debug apple zip Debug apple arp Show appletalk interface Show appletalk neighbor
Additional Commands
Static routes:
Apple static cable-range 10-20 to 50.1 zone MyZone
Apple static network 50 to 50.1 zone MyZone (Phse I)
AURP Tunnel:
Interface tunnel 0
No ip address
Appletalk protocol aurp
Tunnel mode aurp
Tunnel source 10.1.1.1
Tunnel destination 10.1.1.2
<- no cable-range or zone on tun
GRE tunnel Do nor remove the "appletalk iptalk"
Interface tunnel 0 that is automaticaly
Tunnel source 10.1.1.1 placed on the int
Tunnel destintion 10.1.1.2
Tunnel mode gre ip
Appletalk cable-range 20-30
Appletalk zone MyZone
Appletalk protocol eigrp
No appletalk protocol rtmp
Dialer-list 1 protocol appletalk permit
Ị
frame-relay map appletalk 10.2 105 BROADCAST
Spot The Issue
° Appletalk EIGRP requires UNIQUE EIGRP PROCESS
e In "show apple zone" if a zone shows up with
a ":20" this represents a <space> entered at
the end of the zone name Zone names must
"Marketing:20" wouldn't agree
e When you have a GRE tunnel established, try
to tunnel multiple protocols on it rather
than running parallel tunnels
e Doing a "no appletalk routing” then
"appletalk routing" re-initializes appletalk,
BUT, it takes out and replaces all basic
commands (like RTMP) but not commands related
to eigrp or aurp
e AURP uses UDP port 387 Make sure it's NOT
filtered through an access-list!!
Notes
Cable ranges go from 1-253 0, 254 and 255 reserv Ping appletalk codes:
R: unrouteable E: encapsulation failed timeout
On NBMA hubs: appletalk local routing