THIẾT KẾ CHẾ TẠO KHUÔN MẪU ĐỦ 25 BÀI_SPKT_23-EN

– Using tracer to review for parallel scribing.–Milling Milling like parallel planes with knives or knife cylinder head surface.. Tilt embryos by wedging angle• When the pallet onto a v

MOULD HEART BE PROCESSED TILT, 3D

GVHD: TRẦN MINH THẾ UYÊN SVTH : Nguyễn Hoàng Linh MSSV : 12144060

A few examples of products available tilted cavity

I METHOD OF CHICKEN EMBRYO TILT

– Intersection incline is scribing

– Pallet to vice

– Using tracer to review for parallel scribing.–Milling Milling like parallel planes with knives

or knife cylinder head surface

1 The jig according marker

2 Tilt embryos by wedging angle

• When the pallet onto a vise, do not use parallel that used

wedge wedge angle, wedge angle equal to the angle of

3 Holder according to angle size, baseline.

Pressed surface details

Apply alongside vice Face machining

4 By vice Multimeters

5 By tilting universal fixtures

II MILLING INCLINE MACHETER BY CORNER

 When the inclined plane with small width, using machetes corner

III MILLING BY USING INCLINED PLANE TILTED HEAD TOOL

 Formed milling head

 The position of the swivel milling head

 Milling head can be rotated on a plane to

Tilt angle milling head milling

incline angle

α α

1 Milling the inclined plane with the knife cylinder

α =75O

β

Sn

When using a knife face head, milling head tilt angle β=90o-α

2 Milling the inclined plane with the first surface of the knife

IV MILLING SLANTED SURFACE WITH ALMIGHTY SELL ROTATE

1 Milling with hinged swivel table

IV MILLING SLANTED SURFACE WITH ALMIGHTY SELL ROTATE

2 Drilling oblique

V ORDER OF THE MILLING INCLINED PLANE

1 embryos up jig jig.

2 Select and hinged machetes.

3 Adjust the cut.

4 Select the dimension machined.

5 Review knife, adjust

VI CHECK INCLINE PLANE

• Protractors measured in common

• - There are no high precision

• Measured with a multimeter protractors

• - Yes measurement accuracy to 1 '

α =45o

1 Check with nursing protractors

2 Use protractors

- Read the value of the opacity

- Plus part minute (') outlines coincide on travelers spend (like on caliper)

VI MOULD PROCESSING 3D)

1 Zigzac

 Zigzag method usually have 2 options:

 Run knife under 2 road (two way) Run knife in a street (one way)

2 Tooth comb

After each run the knife, knife receded from the face of outsourcing a distance and then ran the initial starting point to cut the next step Run knife method is used when processing crystal surfaces forming steep, narrow grooves

3 Xoắn ốc

Phương pháp chạy dao theo kiểu Spiral: dụng cụ cắt bắt đầu chuyển động từ tâm hoặc điểm bắt đầu của khu vực cần gia công, và tiếp tục gia công khi các khu vực còn lại theo đường xoắn ốc

VII GIA CÔNG KHUÔN 3D

Thank!