Drilling and cutting guide.FIGURE 2-7.. Drilling and cutting guide... The figures depict each piece as if it were laid lengthwise with its two edges on a workbench then flattened so both
Trang 1FIGURE 2-6 Drilling and cutting guide.
FIGURE 2-7 Drilling and cutting guide.
Trang 2B ODY F RAMEWORK 19
that piece The figures depict each piece as if it were laid lengthwise with its two edges on a workbench then flattened
so both sides could be seen All the figures show the locations and diameter of the holes to be drilled The locations of the 45-degree angle cuts to be made at the ends of many of the aluminum pieces are shown as shaded areas where the alu-minum is to be removed
Most of the figures are duplicates of each other The dif-ference between the figures are numbers and sometimes let-ters that appear on the sides of each aluminum piece The numbers are used when the framework is assembled to the two main sections that make up Questor’s body The letters are used when these sections are joined together by two con-necting pieces to form the completed framework In both cases the symbols ensure that all the predrilled holes are
in their correct locations when the framework is completed
To mark the numbers and letters on the outsides of each
FIGURE 2-8 Drilling and cutting guide.
Trang 320 C HAPTER T WO
FIGURE 2-9 Drilling and cutting guide.
Trang 4B ODY F RAMEWORK 21
FIGURE 2-10 Drilling and cutting guide.
Trang 522 C HAPTER T WO
FIGURE 2-11 Drilling and cutting guide.
Trang 6B ODY F RAMEWORK 23
FIGURE 2-12 Drilling and cutting guide.
Trang 724 C HAPTER T WO
FIGURE 2-13 Drilling and cutting guide.
FIGURE 2-14 Drilling and cutting guide.
Trang 8B ODY F RAMEWORK 25
FIGURE 2-15 Drilling and cutting guide.
FIGURE 2-16 Drilling and cutting guide.
Trang 926 C HAPTER T WO
FIGURE 2-17 Drilling and cutting guide.
FIGURE 2-18 Drilling and cutting guide.
Trang 10B ODY F RAMEWORK 27
FIGURE 2-19 Drilling and cutting guide.
FIGURE 2-20 Drilling and cutting guide.