Tài Liêu Lab IIS - DNS

... use the ip nat inside or ip nat outside command: Gateway(config)#interface fastethernet Gateway(config-if)#ip nat inside Gateway(config-if)#interface serial Gateway(config-if)#ip nat outside ... the chart at the end of the lab to correctly identify the interface identifiers to be used based on the equipment in this lab The configuration output used in this lab is produced from 1...

Ngày tải lên: 11/12/2013, 13:15

... Basics v 3.0 - Lab 1.1.6 Copyright  2003, Cisco Systems, Inc Be sure to return to the adapter that displays the NIC or modem data with an IP address Step Check additional TCP/IP configuration ... _ 4-6 CCNA 1: Networking Basics v 3.0 - Lab 1.1.6 Copyright  2003, Cisco Systems, Inc Step Compare the TCP/IP configuration of this computer to others on the LAN If this ... each...

Ngày tải lên: 11/12/2013, 13:15

... Step 12 Trace a local host name or IP address Try using the tracert command with a local host name or IP address It should not take long because the trace does not pass through any routers ... a point where one network connects to another network and the packet was forwarded through Step 11 Trace other IP addresses or domain names Try tracert on other domain names or IP addresse...

Ngày tải lên: 11/12/2013, 13:15

... RIP v2 is now being used instead of RIP v1? c What is the difference between RIP v2 and RIP v1? d What must be done in order to see a difference between RIP v2 and RIP ... Step Enable RIP v2 routing Enable version of the RIP routing protocol on both of the routers, Gadsden and Birmingham GAD(config)#router rip GAD(config-router)#version GAD(config-router)#exit ... 2...

Ngày tải lên: 11/12/2013, 13:15

... locate the RJ-45 connector labeled Console Step Identify the computer serial interface (COM or 2) a Examine the computer and locate a 9-pin or 25-pin male connector labeled serial It may or may ... Routers and Routing Basics v 3.0 - Lab 1.2.5 Copyright  2003, Cisco Systems, Inc Step Connect cabling components a Connect the rollover cable to the router console port, an RJ-45 connecto...

Ngày tải lên: 11/12/2013, 13:15

... is no remainder If necessary, use row four to check the work Position Value 128 64 32 16 1 0 1 1 128 64 = 207 Convert the following decimal values to binary values: a 123 _ b 202 ... 2-2 CCNA 1: Networking Basics v 3.0 - Lab 1.2.5 Copyright  2003, Cisco Systems, Inc

Ngày tải lên: 11/12/2013, 13:15

... chạy IIS) Tài liệu hướng dẫn thực hành LAB MCSA 2008 Bước 3: Cấu hình IIS kiểm tra Start menu > Administrative tools > IIS R-Click athena > Edit Bindings Click Add… Tài liệu hướng dẫn thực hành LAB ... trang web với IIS để truy cập dịch vụ web Start menu > Administrative > IIS Tài liệu hướng dẫn thực hành LAB MCSA 2008 R-Click vào Sites > Add Web Site… Tài liệu hướng dẫ...

Ngày tải lên: 23/10/2015, 18:05