Machinability and Surface Integrity Part 11 ppt
Machinability and Surface Integrity Part 11 ppt
... Secondary Machining Operations and the Re- sulting Surface Integrity: An Overview. Surface Topogra- phy, Vol. 3, 25–42, 1990. Smith, G.T. Some Aspects in the Surface Integrity and Tool Wear Associated ... Fundamentals and Future of Quality, 446–451, 1986. Shiraishi, M. and Sato, S. Dimensional and Surface Rough- ness controls in a Turning Operation. Trans. of ASME, Vol...
Ngày tải lên: 05/08/2014, 21:20
Machinability and Surface Integrity Part 7 pptx
... (isotherms) during machining, illustrated across the: chip, insert and work- piece; at relatively low cutting speed . Machinability and Surface Integrity Figure 173. Finite Element Method (FEM), to ... – is usually the re- sult of tool/workpiece anity associated with tem- Machinability and Surface Integrity perature and its respective cutting speed (i.e. see Fig...
Ngày tải lên: 05/08/2014, 21:20
Machinability and Surface Integrity Part 4 pps
... deviation of a sample from a production batch run. Machinability and Surface Integrity depending upon whether a ne, medium, or coarse surface texture is obligatory. Due to the variability ... such surface texture values do not reect the likely in-service performance of the part. Neither the surface topography, nor its associated integrity has been quantied by assign...
Ngày tải lên: 05/08/2014, 21:20