voice recognition software for gas chromatography olfactometry

... noise robustness for text entry using a technique known as Haptic Voice Recognition (Sim, 2010) Haptic Voice Recognition (HVR) For many voice- enabled applications, users often find voice input to ... in speech recognition In Proc of the IEEE, volume 77, pages 257–286, February K C Sim 2010 Haptic voice recognition: Augmenting speech modality with touch events for efficient speech recognition ... speech recognition When using an HVR interface, users will input text verbally, at the same time provide additional cues in the form of Partial Lexical Information (PLI) to guide the recognition...

Ngày tải lên: 07/03/2014, 18:20

... so-called substitute voice Although the substitute voice resembles laryngeal voice production more than alternative techniques [15], it still shows considerable differences to laryngeal voices It is characterized ... intelligibility Automatic Speech Recognition System For objective measurement, an automatic speech recognition (ASR) system was applied We use an automatic speech recognition system based on Hidden ... that is, the mean of the four other raters for the LE group and the three other raters for the OC group For the comparison between the automatic speech recognition system and the expert ratings,...

Ngày tải lên: 21/06/2014, 20:20

... into the gas chromatograph and tested to be leak free, set the column and detector gas flows Before heating the column, allow the system to purge with carrier gas at ambient temperature for at least ... flammable gas under high pressure.) 7.6 Air—High purity (for example, hydrocarbon free) compressed air is used as the oxidant for the flame ionization detector (FID) (Warning—Compressed air is a gas ... Reference Gas Oil Analysis—The Reference Gas Oil sample is used to verify both the chromatographic and calculation processes involved in this test method Perform an analysis of the gas oil following...

Ngày tải lên: 20/10/2014, 17:18

... Networks for Real-Time Voice Traffic” section for information about how to select and configure the appropriate QoS tools to optimize voice traffic on your network Configure Frame Relay for Voice over ... the 'Configure Voice over IP for Microsoft NetMeeting” section for more information about configuring Voice over IP to support Microsoft NetMeeting Configure IP Networks for Real-Time Voice Traffic ... public Frame Relay cloud provides no guarantees for QoS Refer to the “Configure Frame Relay for Voice over IP” section for information about deploying Voice over IP over Frame Relay Configure Number...

Ngày tải lên: 22/10/2013, 09:15

... Chapter 1: General Information Introduction 1: General Information Introduction Asian 2003 is a software program for the Next Generation Information System (NGIS) tool With the software installed ... and reuse saved information for a vehicle already tested Do one of the following: • To enter new information for a vehicle, go to step and then step • To reuse saved information for a vehicle already ... 1) entering new information for a vehicle, 2) selecting and reusing information for a vehicle previously tested, and 3) viewing demonstration data For detailed information about using this screen,...

Ngày tải lên: 12/12/2013, 21:16

... in a pseudo formalism which attempts to be both intuitive for linguists and relatively straightforward to code (for the time being, this is done manually) The conditions take the form of boolean ... L stands for the possibly empty list of left constituents, X for the (possibly empty) head of the phrase and R for the (possibly empty) list of right constituents The possible values for X are ... the cursor on the specific word for which help is requested, or navigate word by word in the sentence XP • For each word, the system retrieves from the tagged information the relevant lexeme and...

Ngày tải lên: 20/02/2014, 12:20

... Suitable for manual, automated and robotic welding argon Use for sheet and plate up to 9mm thick Suitable for pulse techniques 28 WwW.oto-hui.com THE RIGHT GAS Gases for TIG welding Shielding gas ... The efficiency of the gas shield is critically dependent on the design of the nozzle tungsten electrode uniform laminar gas flow Gases for TIG welding Pure argon Suitable for all metals Alumaxx™ ... preferred for the welding of steels containing 5% Cr Always seek technical advice before recommending a gas for these steels Benefits of Ferromaxx™ less spatter smooth surface stable arc gives uniform...

Ngày tải lên: 25/02/2014, 10:20

... notification or information icons, and the order of the information about the graphical information should not interfere with other important information in the UI For instance, information about ... Engineering Software for Accessibility WinEvents used in MSAA, UIA Events use a subscription mechanism, rather than a broadcast mechanism, to obtain information UIA Clients register for UIA Events for ... Engineering Software for Accessibility Editor One Microsoft Way Redmond, WA 98052-6399 Please note that Microsoft software product support is not offered through these addresses References Forrester...

Ngày tải lên: 08/03/2014, 11:20

... is raised above the limit of decomposition for the oxide (from 600 ◦ C for zinc oxide to 1500 ◦ C for indium oxide) [16] A controlled flow of inert gas (usually argon) is maintained during decomposition ... obtained for an operating temperature of 400 ◦ C for both the samples Optical characterization Photoluminescence (PL) spectroscopy was performed over a wide temperature and wavelength range for the ... solid-state gas sensors with superior performance-NANOS4” STREP project no 001528 “Nanostructured semiconductors for chemical sensing” PRIN project 2004 “Quasi mono dimensional nanosensors for label...

Ngày tải lên: 16/03/2014, 15:25

... Successive inected morphemes form a word and the combined form of the rst and the last morphemes tag represents its tag For example, the morpheme-unit POS (gass-eoss-da) tagged form of the Eojeol is ... cases of considering frequency are better for precision but worse for recall, and better for F-measure The representation schemes using single syllable information (e.g BIS, IES) are better than ... level form and the lexical level one in recognizing words We have performed various experiments with a wide range of variables inuencing the performance such as the representation schemes for the...

Ngày tải lên: 17/03/2014, 06:20

... their systems, the ISA analysis is performed before the plan recognition phase In our system, the presence of "compiled" metaplans for ISA allows indirect forms to be considered easily, but they ... explicit rules for tracking shifts in the task structure From an utterance, she recognized part of the task plan, which was then used as an expectation structure for future plan recognition For example, ... discussed later, many conventional indirect speech acts can be accounted for using a metaplan for each form 2.2 Plan Recognition The plan recognizer attempts to recognize the plan(s) that led...

Ngày tải lên: 17/03/2014, 19:21

... 600–900 ◦ C [19] Since ionic radii for Al and Ti are close to each other (0.074 nm for Ti4+ and 0.0675 nm for Al3+ ) [20], Al can occupy a regular cation position, forming a substitutional solid ... meters, and for all of these tests, the total gas flow rate was fixed at 150 cm3 min−1 Air, pure nitrogen and CO gases were allowed to mix during their passage to the test setup Before electrical ... area for all calcination temperatures; however, a drop at wt.% Al is also seen The highest surface area of 25 m2 /g is observed for the pure TiO2 powders calcined at 700 ◦ C for h TEM images for...

Ngày tải lên: 19/03/2014, 16:47

... to form printable ink The ink was deposited on sensor microheater platform, dried for 15 at 150 ◦ C and annealed at 700 ◦ C for 15 to reach the stabilization of the material The sensor platforms ... SnO2 nanopowders before heat treatment, calculated using TOPAS software, was equal to 1.3 and 30 nm for synthesized and commercial SnO2 , respectively The temperature range for TXRD study of crystallite ... of propane in synthetic air at 50% RH The gas concentrations and gas humidification were prepared with gas mixing system Environics 4000 at 20 ◦ C Before the measurements all sensors were stabilized...

Ngày tải lên: 19/03/2014, 16:47

... candidate of gas- sensing applications [15–17] For the gas- sensing materials, there are various approaches using CNTs as the solution such as CNTs for dispersion, CNTs for composite, CNTs for filling, ... Rotary Pump provide excellent gas absorption properties These extreme absorption properties make CNTs advantageous for use in many areas of applications For example, the gas absorption of CNTs at ... result in a remarkable improvement of the hybrid CNTs/SnO2–TiO2 gas- sensor performance The improvement of the SnO2–TiO2 gas- sensor performance by including SWCNTs has not been well understood so...

Ngày tải lên: 20/03/2014, 13:04

... carried out in the gas flow bench set-up at SUNY, Stony Brook.12 The gases used in the sensing setup were UHP nitrogen (Praxair), UHP oxygen (Praxair), 1000 ppm ammonia in nitrogen (BOC gases) Concentration ... rates The gases were controlled through 1479 MKS Mass flow controllers whose channels were connected to a Type 247-MKS 4-channel readout which is calibrated to read the flow rate of the gases directly ... read the flow rate of the gases directly in sccm The combined flow rate of the gases was maintained at 1000 sccm The gas mixture is passed through a tube furnace (Lindberg/Blue), which Fig XRD patterns...

Ngày tải lên: 20/03/2014, 13:05

... using a gas- tight chromatographic syringe Specifically, these concentrations were: 100, 200, 500 and 1000 ppb for NO2 ; 10 and 50 ppm for CO; 2, and 10 ppm for NH3 and 50 and 150 ppm for C6 H6 ... p-type at 1/250 wt% For the measurements performed at 250 ◦ C, the response time to 100 ppb and to 500 ppb of NO2 was around both for the hybrid materials based on WO3 and for the pure WO3 sensors ... Carbon nanotube sensors for gas and organic vapor detection, Nano Lett (2003) 929–933 [4] Y Lu, C Partridge, M Meyyappan, J Li, A carbon nanotube sensor array for sensitive gas discrimination using...

Ngày tải lên: 20/03/2014, 13:05

... should be established for each Over time, LFM data should be documented for all routine sample sources for the laboratory A laboratory fortified sample matrix should be analyzed for every 20 samples ... then a LFB for each Aroclor is not required At least one LFB containing toxaphene should be extracted for each 24 hour period during which extractions are performed Toxaphene should be fortified ... solution to fortify the actual water samples (see Section 11.1.3 and Section 11.2.3) Similarly, prepare both surrogate compound solutions (500 µg/mL for calibration, 50 µg/mL for fortification)...

Ngày tải lên: 22/03/2014, 14:20

... information about the various FBs Further Information PID Control is a subset of Standard Control For further information about the standard controller, refer to /350/ 1-2 Standard Software for ... /231/ User Manual: Standard Software for S7 and M7, STEP /232/ Manual: Statement List (STL) for S7-300 and S7-400, Programming /234/ Programming Manual: System Software for S7-300 and S7-400 Program ... Index-1 Standard Software for S7-300 and S7-400 – PID Control C79000-G7076-C516-01 v vi Standard Software for S7-300 and S7-400 – PID Control C79000-G7076-C516-01...

Ngày tải lên: 22/03/2014, 23:20