... OFSOUND ANDVIBRATIONJournal of Sound and Vibration 284 (2005) 23–49 Modeling and analysis of a cracked composite cantilever beam vibrating in coupled bending and torsion Kaihong Wanga, Daniel J Inmana, ... loading during normal flight or impact loading duringmaneuvering, taking off and landing Vibration characteristics of the cracked composite wingcould be important to the earlier detection and ... (EI and GJ) and the coupling term ðCÞ are determined by the fiber angle andfiber volume fraction, and no crack is involved Since the stiffness parameters as well as the coupling term are determined
Ngày tải lên: 25/11/2016, 21:53
... Research Article Error Modeling and Analysis for InSAR Spatial Baseline Determination of Satellite Formation Flying Jia Tu, Defeng Gu, Yi Wu, and Dongyun Yi Department of Mathematics and Systems Science, ... determined on the mm/s level, its influence inthe temporal baseline can be neglected Therefore, the accuracy of interferometric baseline is mainly determined by the accuracy of spatial baseline ... process of spatial baseline determination consists of relative positioningand baseline transformation.Figure 2is the geometric relation for spatial baseline determina-tion Relative positioning is
Ngày tải lên: 02/11/2022, 09:27
Tài liệu An Introduction to Intelligent and Autonomous Control-Chapter 8: Modeling and Analysis of Artificially Intelligent Planning Systems ppt
... monitoring, world modeling, and planner design are all treated in more detail in [1] 2.3 Issues and Techniques in AI Planning Systems In this section we briefly outline some of the issues and techniques ... used since the value of the state is determined or estimated Execution monitoring uses the estimated domain state and the problem domain inputs and outputs to determine if everything is going as ... the modeling and analysis of plan generation in AI planning systems Section 6 provides some concluding remarks and indicates some important research directions, 2 ARTIFICIAL INTELLIGENCE PLANNING
Ngày tải lên: 14/12/2013, 12:15
mcgraw hill - simulation modeling and analysis - third edition - averill m law - w david kelton
... closed-form solution obtainable with just plex, requiring vast computing resources; inverting a large nonsparse matrix is a in principle, but obtaining it numerically in a given instance is far from ... the interarrival times A,, A,, and the service times by F, and F, respectively (In general, F, and F; would be determined by collecting data from the system of interest and then specifying ... program: A subprogram that invokes the timing routine to determine the next event and then transfers control to the corresponding event routine for termination and invoke the report generator
Ngày tải lên: 12/05/2014, 05:42
Quantitative Methods and Applications in GIS - Chapter 3 pptx
... Spatial Smoothing and Spatial Interpolation This chapter covers two more generic tasks in GIS-based spatial analysis: spatial smoothing and spatial interpolation. Spatial smoothing and spatial ... LLC Spatial Smoothing and Spatial Interpolation 37 attributes by origins. Since the table only contains distances within the threshold, only those objects (destinations) within the window ... method Ordinary Kriging... information and better interface (Chang, 2004, p 298) 3. 4 CASE STUDY 3B: SURFACE MODELING AND MAPPING OF TAI PLACE-NAMES IN SOUTHERN CHINA This project continues
Ngày tải lên: 11/08/2014, 17:22
Quantitative Methods and Applications in GIS - Chapter 4 pptx
... studies In this case, the methods are used in delineating hinterlands(influential areas) for major cities in northeast China Delineation of hinterlands is an important task for regional planning The ... shown in Figure 4.1a Second, in Figure 4.1b, linesare drawn to connect points that are near each other, and lines are drawn perpen-dicular to the connection lines at their midpoints Finally, in ... increases and d2x decreases, indicating that the breaking point (BP) shifts toward store 2 and the trade area for store 1 expands The observation is straightforward It is also interesting to examine
Ngày tải lên: 11/08/2014, 17:22
Quantitative Methods and Applications in GIS - Chapter 5 pps
... (potential vs revealed, and spatial vs aspatial) into four categories, such as potential spatial access, potential aspatial access, revealed spatial access, and revealed aspatial access (Khan, ... (central city and A i H S d j ij j n = 1 , Trang 3GIS-Based Measures of Spatial Accessibility and Application in Health Care 79combined suburban townships) and used the ratio to explain intraurban ... using a service, and thus be obtained in a survey Most studies examine potential accessi-bility, based on which planners and policy analysts evaluate the existing system of service delivery and
Ngày tải lên: 11/08/2014, 17:22
Quantitative Methods and Applications in GIS - Chapter 6 pdf
... surface modeling indeed exert influence onsurrounding areas and how the influences interact with each other Once the centers are identified, GIS prepares the data of distances and densitiesfor analysis ... goods and services, information and technology, and residents) If the processes result in an increase in activity (e.g., population) in the periphery, the impact is spread If the activity in the ... model in Equation 6.11, it is to minimize where i indexes individual observations There are several ways to estimate the parameters in nonlinear regression (Griffith and Amrhein, 1997, p 265), and
Ngày tải lên: 11/08/2014, 17:22
Quantitative Methods and Applications in GIS - Chapter 7 ppt
... dummy vari-ables Since the 1978 economic reforms in China, and particularly the 1984 urbanreforms, including the urban land use reform and the housing reform, urbanlandscape in China has changed ... fast-changing urban structure in China The chapter is concluded with adiscussion and brief summary in Section 7.5 7.1 PRINCIPAL COMPONENTS AND FACTOR ANALYSIS Principal components and factor analysis ... first standardized 1 prior to the PCA and FA analysis, and the initial values for components (factors) are also standardized When both Z k and F j are standardized, the l kj in Equations 7.1 and
Ngày tải lên: 11/08/2014, 17:22
Quantitative Methods and Applications in GIS - Chapter 8 pps
... 1, 6, and 8 are all local maxima, as all the links are pointed inward there In step 4, both polygons 2 and 3 point to 1, and they are grouped into cluster I; polygons 4 and 9 point to 5 and then ... directional link always points toward a higher aggregate score For instance, in Figure 8.3, the arrow points to polygon 1 for the link between 1 and 2 because Q2 < Q1 3 Identifying local minima and ... SPATIALORDER command is available in the ArcPlot module through the ArcInfo Workstation command interface Once the spatial-order value of each polygon is determined, the COLLOCATE command in ArcInfo follows
Ngày tải lên: 11/08/2014, 17:22
Quantitative Methods and Applications in GIS - Chapter 9 pps
... cases in each location), a control file (containing location ID and number of controls in eachlocation), and a coordinates file (containing location ID and Cartesiancoordinates or latitude and longitude) ... 1 Preparing data in ArcGIS for SaTScan: Implementing the Bernoulli modelfor point-based spatial cluster analysis in SaTScan requires three data files: a case file (containing location ID and number ... 2006 12:11 PM Trang 5Spatial Cluster Analysis, Spatial Regression, and Applications 1713 Mapping spatial cluster analysis results: In ArcGIS, join the dBase file Taicluster.gis.dbf to the attribute
Ngày tải lên: 11/08/2014, 17:22
Quantitative Methods and Applications in GIS - Chapter 11 (end) pps
... 1Linear Equations and Application in Simulating Urban Structure This chapter introduces the method for solving a system of linear equations Thetechnique is used in many applications, including ... employment (including both the basic and service employment) in all n tracts, and the service employment in any tract i is determined by population in all n tracts The degree of interaction declines ... respectively, and G and T the matrices defined by g ij (with the constant h) and t ik (with the constant e), respectively Equations 11.2 and 11.3 become Combining Equations 11.4 and 11.5 and rearranging,
Ngày tải lên: 11/08/2014, 17:22
Báo cáo y học: "Genome-wide promoter extraction and analysis in human, mouse, and ra" potx
... After comparing gene boundaries and TSSs to the CpG-islands (see Materials and methods), we found that most RefSeq genes are CpG-island related In total, 68%, 54% and 56% promoters obtained above ... same time, TWINSCAN [14] and other studies [15] have shown that integrating genomic homology information can increase gene-prediction accuracy by about 10% compared with the use of ab initio methods ... mouse and rat genes and orthologous gene sets By aligning all known and predicted transcripts to the latest human, mouse and rat genomes we obtained 34,949, 35,073, 30,679 genes (see Materials and
Ngày tải lên: 14/08/2014, 14:22
Mathematical modeling and analysis of organic bulk heterojunction solar cells
... (a) n-shaped inter-penetrating pillars; (b) square-shaped interpenetrating pillars; (c) randomly-shaped interpenetrating donor- and acceptor-pillars 826.2 Interpenetrating donor- and acceptor-pillars ... ground stateduring di usion (dashed arrow), or may reach the interface and turn into interfacial e/h pairs.(c) Dissociation (solid arrow) and germinate recombination (dashed arrow) of interfacial ... morphologyexperimentally In this context, mathematical modeling and simulations can aid in elucidatingthe process-structure-property relationships in OPV devices Mathematical models have beenwidely applied in studying
Ngày tải lên: 09/09/2015, 11:20
Multiscale modeling and applications in nanotribology
... there are two families of multiscale modeling techniques, namely, hierarchical modeling techniques and concurrent modeling techniques In hierarchical modeling, simulations at a higher resolution ... multiscale modeling and applications regarding to nanotribology will be provided in detail 1.2 Review of Multiscale Modeling Approaches This section will review existing multiscale modeling techniques ... 3 and Model 4 .150 Figure 7.16 The opening displacement U x across the interface of thin-film and substrate .151 Figure 7.17 The opening displacement U y across the interface of thin-film and
Ngày tải lên: 09/09/2015, 17:53
Game theoretic modeling and analysis a co evolutionary, agent based approach
... and constitute the crux of game theoretic modeling and analysis Definitions of core terminologies and concepts Player: A single, indivisible, decision making entity that is participating in ... sustain in a long-term relationship than a single encounter Analysis of interaction in repeated games can provide us with interesting insights into how cooperation can be achieved and sustained ... scientists and researchers To achieve accurate and effective modeling which yields meaningful analysis and insights into game theoretic interaction, the difficulties in analytical and human-based
Ngày tải lên: 14/09/2015, 08:40
System level modeling and analysis of multimedia soc platforms
... estimated [17] by integrating the WCET analysis into the de-coder and taking into account of the actual input data By considering frame type and size,a linear model of MPEG decoding is presented ... Thanks also go to Lin Ma, Balaji Raman, Huaxin Xu, Qinghua Trang 3Last, my most tender and sincere thanks go to my wife, Lili Zhang Thanks for herself-giving help and support in innumerable ways.iii ... and Dr Ee-Chien Chang, for many useful interactions, and for contributing their broadperspective in refining the ideas in this dissertation I would like to thank the National University of Singapore
Ngày tải lên: 14/09/2015, 08:50
Reliability modeling and analysis with mean residual life
... certain point of time, is an important measure in reliability analysis and modeling It offers condensed information for various decision-making problems, such as optimizing burn-in test, planning ... deteriorate In literature, there are several definitions for UBMRL and BFR Mi (1995) defined a bathtub curve by three segments: increasing (decreasing), constant and decreasing (increasing) Definition ... The two common ways in modeling are parametric modeling and nonparametric method For the parametric modeling, an underlying distribution needs to be predetermined before the analysis of failure
Ngày tải lên: 14/09/2015, 08:50
Software reliability modeling and analysis
... Trang 1SOFTWARE RELIABILITY MODELING AND ANALYSISHU QINGPEI NATIONAL UNIVERSITY OF SINGAPORE 2006 Trang 2SOFTWARE RELIABILITY MODELING AND ANALYSISHU QINGPEI (M Eng, BUAA) A THESIS SUBMITTED ... knowledge from experts will also be explored in case of introducing more uncertainty and possible inconsistency into the modeling framework The remainder of this thesis is organized as follows ... reasoning under uncertainty and it can describe the inspection procedure well With a modeling framework, some further extensions can be explored Specifically, the number of remaining defects in
Ngày tải lên: 14/09/2015, 18:29
Probabilistic modeling and reasoning in multiagent decision systems
... Trang 1PROBABILISTIC MODELING AND REASONING IN MULTIAGENT DECISION SYSTEMS ZENG YIFENG NATIONAL UNIVERSITY OF SINGAPORE 2005 Trang 3PROBABILISTIC MODELING AND REASONING IN MULTIAGENT DECISION ... Research in decision analysis, artificial intelligence, operations research, and other disciplines has led to various techniques for analyzing, representing, and solving decision problems in uncertain ... much effort into the correction of confusing sentences, and given useful remarks on my research The members of the system modeling and analysis laboratory (SMAL), including Han Yongbin, Liu Na,
Ngày tải lên: 15/09/2015, 17:10