code of practice for use of masonry

... normal codes of practice Typically, for example, the performance specification might state:- “The design must comply with the Code of Practice for the Structural Use of Steel 2005” When used in ... of the principles of limit state design, has been covered in clause 1.2 in outline and in clause 2.2 of the Code Individual load types are covered in clause 2.5 of the Code Section 4 of the Code ... background information and considerations reviewed in the preparation of the Code of Practice for the Structural Use of Steel 2005 (the ‘Code’), and should be read in conjunction with the Code Elaborations

Ngày tải lên: 30/04/2018, 09:04

... centre-lines of ducts in plane of curvature Table 5.1 — Allowances for effects of spalling at supports Table 5.2 — Allowances for effects of spalling at supported members Table 5.3 — Values of tan af for ... design moments in panels of flat slabs Table 3.19 — Values of ¶ for braced columns Table 3.20 — Values of ¶ for unbraced columns Table 3.21 — Values of ¶a Table 3.22 — Values of the coefficient ¶ ... combinations and values of ¾f for the ultimate limit state Table 2.2 — Values of ¾m for the ultimate limit state Table 3.1 — Strength of reinforcement Table 3.2 — Classification of exposure conditions

Ngày tải lên: 04/11/2019, 09:48

... Government Association Shire of Gingin Shire of Serpentine Jarrahdale Environmental Code of Practice for Poultry Farms in Western Australia Trang 3Environmental Code of Practice for Poultry Farms in ... Cost of Production Model, within the Review of Farm Model for broilers. Minimum equipment requirements for all poultry industries are included in the Model Code of Practice for the Welfare of Animals ... practices as an industry standard andencouraging farmers to meet this standard This Environmental Code of Practice replaces the WA Environmental Protection Authority’s Environmental Code of Practice

Ngày tải lên: 17/03/2014, 10:20

... on 7 July 1998 approved the Code of Practice entitled Safe use of lifting equipment. The Code of Practice gives practical guidance with respect to the requirements of the Lifting Operations ... report of a thorough examination 59 Schedule 2 Revocation of instruments 60 References 62 Safe use of lifting equipment Page 4 of 63 Health and Safety Executive Notice of Approval By virtue of ... 2008 to form a single national regulatory body. From that date, the Health and Safety Executive became responsible for approving Codes of Practice, with the consent of the Secretary of State. *

Ngày tải lên: 23/03/2014, 23:20

... but which had not been settled before 1 October 2010, the taxpayer may choose whether the settlement is made under the terms of this Code or the Code of Practice for Revenue Auditors 2002 The penalties, ... of Revenue that there is no loss of revenue Where this onus of proof is not met, the ‘no loss of revenue’ arrangements will not apply ‘No Loss of Revenue’ claims will not be accepted in any of ... generally based on informed selections from the risk profiling of cases, including assisted profiling as well as local knowledge Audit cases may also be selected for examination of a particular sector

Ngày tải lên: 29/03/2014, 22:20

... 3.1: Code of practice for design of simple and continuous composite beams; — Part 4: Code of practice for design of composite slabs with profiled steel sheeting; — Part 5: Code of practice for ... design of cold formed sections; — Part 61): Code of practice for design of light gauge profiled sheeting; — Part 7: Specification for materials and workmanship: cold formed sections; — Part 8: Code ... Code of practice for fire resistant design; — Part 9: Code of practice for stressed skin design. This Part of BS 5950 gives recommendations for the design of composite slabs in which profiled

Ngày tải lên: 08/07/2014, 22:20

... Structural use of steelwork in building Code of practice for design of cold formed sections Loading for buildings Code of practice for dead and imposed loads Code of practice for wind loading Code of practice ... construction Code of practice for design of simple and continuous composite beams Code of practice for design of composite slabs with profiled steel sheeting Code of practice for design of cold formed sections ... sections Code of practice for design of light gauge profiled steel sheeting Specification for materials and workmanship: cold formed sections Code of practice for fire resistant design Code of practice

Ngày tải lên: 08/07/2014, 22:20

... Section 3.1: Code of practice for design of simple and continuous composite beams; — Part 4: Code of practice for design of floors with profiled steel sheeting; — Part 5: Code of practice for design ... experienced organizations This code of practice represents a standard of good practice and therefore takes the form of recommendations 1) In preparation. Trang 7The full list of organizations who have ... for design in cold formed sections; cladding; — Part 8: Code of practice for fire resistant design; This Part of BS 5950 gives recommendations for evaluating the fire resistance of steel structures

Ngày tải lên: 08/07/2014, 22:20

... Part 4: Code of practice for design of composite slabs with profiled steel sheeting; — Part 5: Code of practice for design of cold formed sections; — Part 61): Code of practice for design of light ... gauge profiled sheeting; — Part 7: Specification for materials and workmanship: cold formed sections; — Part 8: Code of practice for fire resistant design; — Part 9: Code of practice for stressed ... 1 and 2Structural use of steelwork in building — Part 9: Code of practice for stressed skin design Trang 2This British Standard, having been prepared under the direction of Technical Committee

Ngày tải lên: 08/07/2014, 22:20

... Specification for SI units and recommendations for the use of their multiples and of certain other units Loading for buildings Code of practice for wind loads Code of practice for imposed roof loads ... construction on change of use It does not apply to the maintenance of, or the replacement of parts of, existing buildings and structures where there is no change of use 1.2 This code of practice does ... height of the space between a floor and a physical constraint to the height of storage formed by a ceiling, soffit of a floor, roof or other obstruction 3.4 wind load The load due to the effect of

Ngày tải lên: 08/07/2014, 22:20

... coefficients Cpe for walls of circular-plan buildings 2.5 External pressure coefficients for roofs 2.5.1 Flat roofs 2.5.1.1 Scope The data in this section should be used for all roofs of pitch a less ... 15 — Keys for walls of inset storey 28 Figure 17 — Key to eave details for flat roofs 32 Figure 22 — Key for mansard and multipitch roofs 38 Figure 24 — Key for free-standing canopy roofs 42Figure ... angle of the upwind face is used for each wind direction, as indicated in Figure 21 Negative pitch angles occur when the roof is a hipped-trough form For pressure coefficients for skew-hipped roofs

Ngày tải lên: 08/07/2014, 22:20

... & Mechanical Services Department The set of comprehensive Building Energy Codes cover this Code, the Codes of Practice for Energy Efficiency of Lighting Installations, Electrical Installations, ... Trang 3Foreword The Code of Practice for Energy Efficiency of Air Conditioning Installations aims to set out the minimum design requirements on energy efficiency of air conditioning ... building” means a building constructed, used or intended to be used for habitation but excluding the use of it for hotel, guest-house, boarding-house, hostel, dormitory or similar accommodation and the

Ngày tải lên: 28/09/2014, 23:44

... corresponding to the clauses of Code of Practice for Energy Efficiency of Electrical Installations * - delete as appropriate... _ Page 13 of 46 Code of Practice for Energy ... Page 12 of 46 Code of Practice for Energy Efficiency of Electrical Installations _ SCHEDULE OF FORMS Page FORM EL-1: Electrical Installations Summary 14 FORM EL-2: ... with the Code of Practice for Energy. .. Installations (Clause 5.2) Do the air conditioning installations comply with the Code of Practice for Energy Efficiency of Air

Ngày tải lên: 28/09/2014, 23:44

... Region Code of Practice on the Building Works for Lifts and Escalators, 1993 Edition, published by Buildings Department, Government of The Hong Kong Special Administrative Region Code of Practice for ... Department) This Code was first published in 1998 by the Electrical & Mechanical Services Department The set of comprehensive Building Energy Codes cover this Code, the Codes of Practice for Energy ... exclusion of the following installations : a) Builders' lifts used for vertical transportation of persons in a building construction site b) Hoists used for vertical transportation of materials

Ngày tải lên: 28/09/2014, 23:44

... Control Points for Office Space < 200m2 9 Table (LG6) : Minimum Number of Lighting Control Points for Office Space > 200m2 10 Schedule of Forms : FORM LG-(G) - Summary of Information on ... 17Schedule of Forms FORM LG -(G) : Summary of Information on Lighting Installations FORM LG -1 : Data of Lamps & Luminaires FORM LG -2 : Lighting Power Density FORM LG -3 : List of Submitted ... Gallery 25 Trang 14Code of Practice for Energy Efficiency of Lighting Installations Page 8 of 38 Table (LG4) : Maximum Allowable Values of Lighting Power Density for Various Types of Space (Continued)

Ngày tải lên: 28/09/2014, 23:45

... function of the amount of reinforcement as well as the expansion of the concrete. The induced compressive stress causes an elastic shortening of the concrete that for practical reinforcement ... 3.2.4 Reinforcing steel— Reinforcement should be either welded wire fabric or deformed bars meeting the require- ments of ACI 318. Plain bar reinforcement shall not be used be- cause adequate ... the ettringite must form after attainment of a certain degree of strength; otherwise the expansive force will dissipate in deformation of the plastic or semiplastic concrete. For this reason, mixing

Ngày tải lên: 24/10/2014, 16:04

... during final trimming of the ship 5.1.4 Any requirement for cargo trimming should be in accordance with the procedures of the IMO Code of Safe Practice for Solid Bulk Cargoes (BC Code) 5.1.5 In order ... and unloading of bulk carriers, RECOGNIZING FURTHER that such improvement could be achieved by the establishment of acomposite code of practice for the safe loading and unloading of bulk carriers, ... 3CODE OF PRACTICE FOR THE SAFE LOADING AND UNLOADING OF BULK CARRIERS CONTENTS Introduction Section 3 - Procedures between ship and shore prior to the ship's arrival Appendix 4 - Guidelines for

Ngày tải lên: 26/04/2016, 08:19

... workmanship: cold formed sections and sheeting. BS 6399-1, Loading for buildings Ð Code of practice for dead and imposed loads. BS 6399-2, Loading for buildings Ð Code of practice for wind loads. BS ... Ð Code of practice for wind loads. BS 6399-3, Loading for buildings Ð Code of practice for imposed roof loads. BS 8004, Code of practice for foundations. ... COPYRIGHT LAW Structural use of steelwork in building Ð Part 5. Code of practice for design of cold formed thin gauge sections BS 5950-5:1998  BSI 1998 17 Section 5. Design of members subject to...

Ngày tải lên: 08/07/2014, 22:20

... edition 2005-06-15 Information technology — Security techniques — Code of practice for information security management Technologies de l'information — Techniques de sécurité — Code de pratique ... how this relates to the protection of confidential information; f) the permitted use of confidential information, and rights of the signatory to use information; g) the right to audit and ... training in the correct use of information processing facilities e.g. log-on procedure, use of software packages and information on the disciplinary process (see 8.2.3). Other Information The security...

Ngày tải lên: 21/02/2014, 10:20

... types of luminaires, their ratings and operating characteristics; Code of Practice for Building Energy Audit EAC_2012 1 of 11 EMSD 1. Introduction 1.1 This Code of Practice titled Code of ... first day of operation of the building; ii) indication of the EUI per annum (MJ/m 2 /annum) (based on the total energy consumption data in item i)), respectively for - Code of Practice for Building ... Audit Form, to reflect the energy usage intensity of the central building services installations. The Energy Audit Form is a specified form under the Ordinance. Code of Practice for Building...

Ngày tải lên: 15/03/2014, 20:20