ccna exploration accessing the wan final exam 2013
Understanding The Routing TableRouting Protocols, Closer Look, CCNA, Accessing the WAN, Implementing IP, Lab Topology potx
... FastEthernet0 C 192.168.1.0/24 is directly connected, Serial1 S* 0.0.0.0/0 is directly connected, Serial1 RouterB# Understanding The Routing Table Part 1: The Routing Table Structure Part 2: The ... default routing behavior, whether classful or classless, is simple. The command to enable classless routing behavior is: RouterB(config)#ip classless RouterB(config)# The command to disable classless ... These 24 bits match! Ultimate Route 192.168.1.0 11000000 10101000 00000001 00000000 Part 2: The Lookup Process 29 Classless and Classful Routing Behavior Changing the...
Ngày tải lên: 18/03/2014, 14:20
Accessing the WAN
... reserved. Cisco Public 11 Select the Appropriate WAN Technology to meet ECNM Requirements List the various options for connecting subscribers to the WAN © 2006 Cisco Systems, Inc. ... Describe how the Cisco Enterprise Composite Model (ECNM) provides integrated services over an Enterprise network. Describe the key WAN technology concepts. Identify the appropriate WAN technologies ... terms of the OSI Reference Model © 2006 Cisco Systems, Inc. All rights reserved. Cisco Public 23 Configuring PPP with Authentication Outline the PPP encapsulation and authentication...
Ngày tải lên: 03/04/2014, 13:52
Accessing the WAN – Chapter 1 ppt
... modulates the binary data into an analog signal at the source and demodulates the analog signal to binary data at the destination. The physical characteristics of the local loop to the PSTN ... –Because it is likely that not all the VCs require maximum demand simultaneously, the capacity of the leased line can be smaller than the sum of the individual VCs. Examples of packet- or cell-switched ... 12 Cisco Thai Nguyen Networking Academy WAN Physical Layer Standards The WAN physical layer also describes the interface between the DTE and the DCE. –EIA/TIA-232 - This protocol allows...
Ngày tải lên: 05/07/2014, 03:20
Accessing the WAN – Chapter 2 docx
... –Data is encapsulated by the sending router. The frame is sent on a physical medium to the WAN. –There are various ways to traverse the WAN, The receiving router uses the same communications ... signal back into a sequence of bits. The remote DCE then signals this sequence to the remote DTE. The connection between the two DCE devices is the WAN service provider transmission network. ... Enter the interface configuration mode of the serial interface. –Step 2. Enter the encapsulation hdlc command to specify the encapsulation protocol on the interface. The output of the show...
Ngày tải lên: 05/07/2014, 03:20
Accessing the WAN – Chapter 3 potx
... unicast so that the other node gets the routing updates. In the example, R1 uses the frame-relay map command to map the VC to R2. To verify the Frame Relay mapping, use the show frame-relay ... savings arise as the capacity of the access line is based on the average bandwidth requirement of the VCs, rather than on the maximum bandwidth requirement. More of this from the old CCNA4 Cisco ... (DE = 0). Excess Burst Size (BE) The BE is the term used to describe the bandwidth available above the CBIR up to the access rate of the link. Unlike the CBIR, it is not negotiated. ãFrames...
Ngày tải lên: 05/07/2014, 03:20
REVISION for The final exam
... Interviewer / wanted / know / conflict / with her son. A. The interviewer wanted knowing the conflict with her son. B. The interviewer wanted to know the conflict with her son. C. The interviewer wanted ... watched them (8) away to the other end of the pool. Luckily, there no-one else in the pool at that moment, but (9) when Simon was swimming to get them, a girl came into the pool and (10) them ... people who hate learning. 22. When there is famine in the country, the people must ______ the good will of other countries to provide them with the goods they need. A. rely on B. rely at C....
Ngày tải lên: 01/09/2013, 15:10
Tài liệu Chapter 2 - Communicating over the Network CCNA Exploration 4.0 docx
... over the Network CCNA Exploration 4. 0CCNA Exploration 4.0 End Devices and their Role on the Network ã The network devices that people are most familiar with are called end devices. These ... Devices and their Role on the Network ã Intermediary devices to provide connectivity and to work behind the scenes to ensure that data flows across the network. ã These devices connect the individual ... functionality, not the underlying technology to support this functionality. Học viện mạng Bách khoa - Website: www.bkacad.com Getting the Data to the End Device ã Describe examples of Ethernet MAC...
Ngày tải lên: 12/12/2013, 14:15
CCNA 2 Final Exam New docx
... changes the source physical address to the physical address of the exit interface. ã The router changes the destination IP to the IP of the exit interface. ã The router sends the packet out all other ... router changes the destination IP to the IP of the exit interface. The router sends the packet out all other interfaces, besides the one it entered the router on. 14. Which of the following are ... in the exhibit. What is the meaning of the highlighted value 192? It is the value assigned by the Dijkstra algorithm that designates the number of hops in the network. It is the value used by the...
Ngày tải lên: 22/06/2014, 16:20
review for the final exam
... relatives (5)_____ either the mother’s or the father’s side of the family. It is made (6)_____ grandparents , parents ,brothers, sisters, uncles, aunts and cousins . They live together in a large ... c) the most famous d) the most well-known 7) Do you know how many sheep ___________ in Australia a) there is b) is there c) are there d) there are 4) An arranged ________ is the one in which the ... (10)___ their parents. Younger members of the joint family always took care of the old ones. 1) a) on b) off c) about d) at 2) a) a b) the c) no article d) an 3) a) another b) others c) other d) the...
Ngày tải lên: 30/06/2014, 23:00