Reverse fold at angle bisector.. Mountain fold three corners behind, starting from the sides.. Squash fold the right triangle at angle bisector.. Reverse fold lower section on both sides
Trang 1A Bug (page 1)
Hugo Pereira ©)2001
Trang 2A Bug (page 2)
13
Hugo Pereira (2001
Trang 3A Bug (page 3)
©2001
Hugo Pereira
Trang 4A Bug (page 4)
Hugo Pereira ©)2001
Trang 510
11
12
13
14
15
16
17
18
19
20
21
22
23
Comments
Start with a one-colour square Mountain fold two corners
Collapse
Turn over
Precrease left and right corners towards the top corner
Reverse fold at angle bisector
Petal fold
Montain fold behind at angle bisector
Valley fold small triangle down ‘Turn over
Petal fold
three consecutive reverse folds, in, out and in
Pull out some paper to form a square
Mountain fold three corners behind, starting from the sides
Precrease in half
Collapse using indicated creases The model will not lie flat
Squash fold the right triangle at angle bisector Reverse fold lower section on both sides
Petal fold
Reverse fold on both side, while pulling out some paper (it corresponds to the
corners hidden at step 12)
Reverse fold on both sides at angle bisector
Reverse fold two flaps on both sides at angle bisector
Valley fold the upper section and flatten the model Hide the top corner behind the small triangle
Reverse fold to form the rear legs
Reverse fold again to form the middle leg
Valley fold up two small triangular flaps, as far as possible
Trang 624
2ð
26
27
28
29
Rabbit ear on each side to form the front legs, using indicated creases Valley fold down the triangular flaps (see step 13) Turn over
Mountain fold one flap at angle bisector Tuck into the pocket behind Valley fold all remaining flaps Tuck into the pocket
Shape the antennas Pinch the legs Shape the body using mountain folds Completed