Tài liệu Shop Manual & ETM BCM KIA Cerato 2010
Trang 12010 > G 1.6 DOHC > Body Electrical System
Component Location
1 Horn switch
2 Relay box (Engine room compartment)
3 Horn (Low pitch - Single)
4 Horn relay
5 Clock spring
2010 > G 1.6 DOHC > Body Electrical System
Removal
Language
Language
Trang 21 Remove the front bumper (Refer to the Body group - front bumper).
2 Remove the bolts and disconnect the horn connectors, then remove the low pitch horn (A)
Installation
1 Install the horns after connecting the horn connectors
2 Install the front bumper
(Refer to the Body group - Front bumper)
Inspection
Test the horn by connecting battery voltage to the 1 terminal and ground the 2 terminal
The horn should make a sound If the horn fails to make a sound, replace it
Horn Relay Inspection
1 Remove the horn relay (A) from the engine room relay box
2 There should be continuity between the No.30 and No.87 terminals when power and ground are connected to the No.85 and No.86 terminals
3 There should be no continuity between the No.30 and No.87 terminals when power is disconnected
Trang 31 Operate the horn, and adjust the tone to a suitable level by turning the adjusting screw
After adjustment, apply a small amount of paint around the screw head to keep it from loosening