CORRECTION Open AccessCorrection: Biofabrication of anisotropic gold nanotriangles using extract of endophytic Aspergillus clavatus as a dual functional reductant and stabilizer Vijay C
Trang 1CORRECTION Open Access
Correction: Biofabrication of anisotropic gold
nanotriangles using extract of endophytic
Aspergillus clavatus as a dual functional
reductant and stabilizer
Vijay C Verma1*, Ravindra N Kharwar2, Santosh K Singh1, Ravindra Solanki3and Satya Prakash4
Correction
Ravindra N Kharwar was inadvertently omitted from
the author list of this article [1] The correct author list
is displayed above.
The Acknowledgement is also amended as follows:
This work is part of the PhD thesis of VCV, and was
financially supported by the Council of Scientific and
Industrial Research (CSIR-09/013(205)/2008/EMR-I,
dt.28-09-2008), New Delhi India Authors are thankful to the
Professor-in-charge, Centre of Experimental Medicine and
Surgery (CEMS), and Head Department of Botany,
Banaras Hindu University Authors also extend their
thanks to Prof Dhananjai Pandey, School of Material
Science and Technology, Institute of Technology, Banaras
Hindu University for assistance with the XRD and AFM
studies and to Dr Madhu Yashpal, Scientist-in-charge,
Electron Microscopy Facility, Department of Anatomy,
Institute of Medical Sciences, Banaras Hindu University,
India, for the TEM analysis of the gold nanoparticles.
Author details
1
Centre of Experimental Medicine and Surgery, Institute of Medical Sciences,
Banaras Hindu University, Varanasi-221005, India.2Mycopathology and
Microbial Technology Laboratory, Centre of Advanced Study in Botany,
Banaras Hindu University, Varanasi 221 005, India.3School of Material Science
and Technology, Institute of Technology, Banaras Hindu University,
Varanasi-221005, India.4National Facility for Tribal and Herbal Medicine, Institute of
Medical Sciences, Banaras Hindu University, Varanasi-221005, India
Received: 28 March 2011 Accepted: 28 March 2011
Published: 28 March 2011
Reference
1 Verma VC, Singh SK, Solanki R, Prakash S: Biofabrication of anisotropic gold nanotriangles using extract of endophytic Aspergillus clavatus as a dual functional reductant and stabilizer.Nanoscale Res Lett 2011, 6:16
doi:10.1186/1556-276X-6-261 Cite this article as: Verma et al.: Correction: Biofabrication of anisotropic gold nanotriangles using extract of endophytic Aspergillus clavatus as a dual functional reductant and stabilizer.Nanoscale Research Letters 2011 6:261
Submit your manuscript to a journal and benefi t from:
7 Convenient online submission
7 Rigorous peer review
7 Immediate publication on acceptance
7 Open access: articles freely available online
7 High visibility within the fi eld
7 Retaining the copyright to your article
Submit your next manuscript at 7 springeropen.com
* Correspondence: chandravcv@gmail.com
1
Centre of Experimental Medicine and Surgery, Institute of Medical Sciences,
Banaras Hindu University, Varanasi-221005, India
Full list of author information is available at the end of the article
Verma et al Nanoscale Research Letters 2011,6:261
http://www.nanoscalereslett.com/content/6/1/261
© 2011 Verma et al; licensee Springer This is an Open Access article distributed under the terms of the Creative Commons Attribution License (http://creativecommons.org/licenses/by/2.0), which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited