HỆ THỐNG ĐIỀU KHIỂN KHÍ XẢ TRÊN TOYOTA CAMRY 2AZ-FE ĐỜI 2006-2011
Trang 1ENGINE
2AZ-FE EXHAUST
EXHAUST PIPE
COMPONENTS
REAR EXHAUST PIPE NO 1 SUPPORT BRACKET
EXHAUST PIPE SUPPORT NO 4
EXHAUST PIPE SUPPORT NO 4
43 (438, 32)
43 (438, 32)
44 (449, 32)
33 (337, 24)
33 (337, 24)
GASKET
GASKET
GASKET
43 (438, 32)
EXHAUST PIPE
SUPPORT NO 4
EXHAUST PIPE SUPPORT NO 4
EXHAUST PIPE
SUPPORT NO 4
EXHAUST PIPE SUPPORT NO 4
Non-reusable part N*m (kgf*cm, ft.*lbf) : Specified torque
43 (438, 32)
CENTER EXHAUST PIPE ASSEMBLY FRONT EXHAUST PIPE ASSEMBLY
HEATED OXYGEN SENSOR
FRONT EXHAUST PIPE NO 1
SUPPORT BRACKET
A135662E01
Trang 2REMOVAL
1 REMOVE TAIL PIPE ASSEMBLY
(a) Remove the 2 nuts and tail pipe assembly
(b) Remove the gasket from the center exhaust pipe
2 REMOVE CENTER EXHAUST PIPE ASSEMBLY
(a) Remove the 2 bolts, 2 nuts and center exhaust pipe assembly
(b) Remove the gasket from the front exhaust pipe
A135689E01
A135690E01
Trang 33 REMOVE FRONT EXHAUST PIPE ASSEMBLY
(a) Remove the 2 nuts
(b) Remove the 2 nuts, front exhaust pipe No 1 support bracket and front exhaust pipe assembly
(c) Remove the gasket from the exhaust manifold
4 REMOVE HEATED OXYGEN SENSOR (See page EC-24)
5 REMOVE REAR EXHAUST PIPE NO 1 SUPPORT BRACKET
(a) Remove the 2 bolts and rear support bracket
INSTALLATION
1 INSTALL REAR EXHAUST PIPE NO 1 SUPPORT BRACKET
(a) Install the rear support bracket with the 2 bolts
Torque: 33 N*m (337 kgf*cm, 24 ft.*lbf) NOTICE:
Be sure to install the bracket in the correct direction.
2 INSTALL HEATED OXYGEN SENSOR (See page EC-24)
3 INSTALL FRONT EXHAUST PIPE ASSEMBLY
(a) Install a new gasket onto the front exhaust pipe assembly
A135691
Bracket
A132948E01
A060823E04
Trang 4(b) Install the front exhaust pipe assembly with the 2 nuts
Torque: 43 N*m (438 kgf*cm, 32 ft.*lbf)
(c) Install the front exhaust pipe No 1 support bracket with the 2 nuts
Torque: 33 N*m (337 kgf*cm, 24 ft.*lbf)
4 INSTALL CENTER EXHAUST PIPE ASSEMBLY
(a) Install a new gasket onto the front exhaust pipe (b) Install the center exhaust pipe assembly with the 2 bolts and 2 nuts
A135691
A135690E01
Trang 5Torque: 43 N*m (438 kgf*cm, 32 ft.*lbf)
5 INSTALL TAIL PIPE ASSEMBLY
(a) Install a new gasket onto the tail pipe assembly
(b) Install the tail pipe assembly with the 2 nuts
Torque: 43 N*m (438 kgf*cm, 32 ft.*lbf)
6 CHECK FOR EXHAUST GAS LEAKS
If gas is leaking, tighten the areas necessary to stop the leak Replace the damaged parts as necessary
A135689E01