NORME CEI INTERNATIONALE IEC INTERNATIONAL 94 7 STANDARD 1986 AMENDEMENT 1 AMENDMENT 1 1996 02 Amendement 1 Systèmes d''''enregistrement et de lecture du son sur bandes magnétiques Septième partie Casset[.]
Trang 1NORME CEI
AMENDEMENT 1 AMENDMENT 1
1996-02
Amendement 1
Systèmes d'enregistrement et de lecture
du son sur bandes magnétiques
-Septième partie:
Cassette pour enregistrements du commerce
et à usage grand public
Amendment 1
Magnetic tape sound recording and
reproducing systems
-Part 7:
Cassette for commercial tape records and
domestic use
© CEI 1996 Droits de reproduction réservés — Copyright — all rights reserved
Bureau Central de la Commission Electrotechnique Inte rn ationale 3, rue de Varembé Genève, Suisse
Me>eayHapoAHaa 3neKTpoTexte1 ecsas KOMHCCH57
Pour prix, voir catalogue en vigueur
Trang 2FDIS Rapport de vote
1006/19/RVD 60A/179/FDIS
- 2 - 94-7 amend 1 ©CEI:1996
AVANT-PROPOS
Le présent amendement a été établi par le sous-comité 60A: Enregistrement sonore, du
comité d'études 60 de la CEI: Enregistrement
Le texte de cet amendement est issu des documents suivants:
Le rapport de vote indiqué dans le tableau ci-dessus donne toute information sur le vote
ayant abouti à l'approbation de cet amendement
Page 10
12.3.4 Orifices sensibles pour les bandes IEC type Ill
Remplacer «A l'étude» par «Non spécifié ».
Page 12
12.8 Patin presseur
Remplacer le paragraphe existant par ce qui suit:
12.8 Patin presseur
Les dimensions du patin presseur doivent être indiquées dans la figure 4 de la page 18
Lorsque la tête d'enregistrement et/ou de lecture est placée dans la cassette, avec la
profondeur conforme à celle qui est indiquée à la figure 5, la force exercée par le patin
presseur dans la région de l'entrefer doit être comprise entre 0,1 N et 0,25 N
Trang 3FDIS Repo rt on voting
1006/19/RVD 60A/179/FDIS
94-7 Amend 1 © IEC:1996 3
-FOREWORD
This amendment has been prepared by sub-committee 60A: Sound recording, of IEC
technical committee 60: Recording
The text of this amendment is based on the following documents:
Full information on the voting for the approval of this amendment can be found in the
repo rt on voting indicated in the above table
Page 11
12.3.4 Sensing holes for lEC type Ill tapes
Replace "Under consideration" by "Not specified".
Page 13
12.8 Pressure pad
Replace the existing subclause by the following:
12.8 Pressure pad
The dimensions of the pressure pad shall be as given in figure 4, page 18 When the
record/playback head is inserted into the cassette in accordance with the depth given
in figure 5, the force of the pressure pad in the magnetic head gap area shall be between
0,1 N and 0,25 N
Trang 4ICS 33.160.30
Typeset and printed by the IEC Central Office GENEVA SWITZERLAND