Microsoft Word C043553e doc ICS 83 080 01 Ref No ISO 16012 2004/Cor 1 2005(E) © ISO 2005 – All rights reserved Published in Switzerland INTERNATIONAL STANDARD ISO 16012 2004 TECHNICAL CORRIGENDUM 1 Pu[.]
Trang 1ICS 83.080.01 Ref No ISO 16012:2004/Cor.1:2005(E)
© ISO 2005 – All rights reserved
Published in Switzerland
INTERNATIONAL STANDARD ISO 16012:2004
TECHNICAL CORRIGENDUM 1
Published 2005-12-01
INTERNATIONAL ORGANIZATION FOR STANDARDIZATION • МЕЖДУНАРОДНАЯ ОРГАНИЗАЦИЯ ПО СТАНДАРТИЗАЦИИ • ORGANISATION INTERNATIONALE DE NORMALISATION
Plastics — Determination of linear dimensions of test
specimens
TECHNICAL CORRIGENDUM 1
Plastiques — Détermination des dimensions linéaires des éprouvettes
RECTIFICATIF TECHNIQUE 1
Technical Corrigendum 1 to ISO 16012:2004 was prepared by Technical Committee ISO/TC 61, Plastics, Subcommittee SC 2, Mechanical properties
Page 4, Subclause 5.7
In the second line of the second paragraph, replace “7 µm to 10 µm” by “7 mm to 10 mm”
Copyright International Organization for Standardization
Provided by IHS under license with ISO
Not for Resale
No reproduction or networking permitted without license from IHS