Microsoft Word C046512e doc Reference number ISO 9902 7 2001/Amd 1 2009(E) © ISO 2009 INTERNATIONAL STANDARD ISO 9902 7 First edition 2001 03 15 AMENDMENT 1 2009 03 15 Textile machinery — Noise test c[.]
Trang 1Reference number ISO 9902-7:2001/Amd.1:2009(E)
INTERNATIONAL STANDARD
ISO 9902-7
First edition 2001-03-15
AMENDMENT 1
2009-03-15
Textile machinery — Noise test code —
Part 7:
Dyeing and finishing machinery
AMENDMENT 1
Matériel pour l'industrie textile — Code d'essai acoustique — Partie 7: Machines de teinture et de finissage
AMENDEMENT 1
Copyright International Organization for Standardization
Provided by IHS under license with ISO
Trang 2`,,```,,,,````-`-`,,`,,`,`,,` -This PDF file may contain embedded typefaces In accordance with Adobe's licensing policy, this file may be printed or viewed but
shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing In
downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy The ISO Central Secretariat
accepts no liability in this area
Adobe is a trademark of Adobe Systems Incorporated
Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation
parameters were optimized for printing Every care has been taken to ensure that the file is suitable for use by ISO member bodies In
the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below
COPYRIGHT PROTECTED DOCUMENT
© ISO 2009
All rights reserved Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means,
electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or
ISO's member body in the country of the requester
ISO copyright office
Case postale 56 • CH-1211 Geneva 20
Tel + 41 22 749 01 11
Fax + 41 22 749 09 47
E-mail copyright@iso.org
Web www.iso.org
Published in Switzerland
Copyright International Organization for Standardization
Provided by IHS under license with ISO
Trang 3`,,```,,,,````-`-`,,`,,`,`,,` -ISO 9902-7:2001/Amd.1:2009(E)
Foreword
ISO (the International Organization for Standardization) is a worldwide federation of national standards bodies (ISO member bodies) The work of preparing International Standards is normally carried out through ISO technical committees Each member body interested in a subject for which a technical committee has been established has the right to be represented on that committee International organizations, governmental and non-governmental, in liaison with ISO, also take part in the work ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization
International Standards are drafted in accordance with the rules given in the ISO/IEC Directives, Part 2
The main task of technical committees is to prepare International Standards Draft International Standards adopted by the technical committees are circulated to the member bodies for voting Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote
Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights ISO shall not be held responsible for identifying any or all such patent rights
Amendment 1 to ISO 9902-7:2001 was prepared by Technical Committee ISO/TC 72, Textile machinery and accessories, Subcommittee SC 8, Safety requirements for textile machinery
Copyright International Organization for Standardization
Provided by IHS under license with ISO
Trang 5
`,,```,,,,````-`-`,,`,,`,`,,` -ISO 9902-7:2001/Amd.1:2009(E)
Textile machinery — Noise test code —
Part 7:
Dyeing and finishing machinery
AMENDMENT 1
Page 1, Scope
Replace the second paragraph with the following:
It is applicable to engineering (grade 2) and survey (grade 3) methods, in accordance with the International Standards to which it makes normative reference, and to machines of different types used
as defined in ISO 1506 for
⎯ preparation,
⎯ dyeing,
⎯ printing, coating,
⎯ fixing wetting and drying,
⎯ finishing,
⎯ calendering, and
⎯ making-up of presentation
It is not applicable to machines for hydro (centrifugal) extraction
Page 1, Normative references
Delete the year of publication for the following references:
ISO 1506 ISO 3744 ISO 3746 ISO 3747
Page 2, Normative references
Delete the year of publication for the following references:
ISO 9614-1 ISO 9614-2 ISO 11201 ISO 11202 ISO 11204
Copyright International Organization for Standardization
Provided by IHS under license with ISO
Trang 6`,,```,,,,````-`-`,,`,,`,`,,` -2 © ISO 2009 – All rights reserved
Add the following reference:
ISO 9902-1:2001/Amd.1:2009, Textile machinery — Noise test code — Part 1: Common requirements
Page 3, 5.2
Replace the first sentence with the following:
See 5.2 of ISO 9902-1:2001, as amended by ISO 9902-1:2001/Amd.1:2009
Page 9, Clause 12
Replace with the following:
See Clause 12 of ISO 9902-1:2001, as amended by ISO 9902-1:2001/Amd.1:2009
Copyright International Organization for Standardization
Provided by IHS under license with ISO
Trang 7`,,```,,,,````-`-`,,`,,`,`,,` -Copyright International Organization for Standardization
Provided by IHS under license with ISO
Trang 8ICS 17.140.20; 59.120.50
Price based on 2 pages
© ISO 2009 – All rights reserved
Copyright International Organization for Standardization
Provided by IHS under license with ISO