Microsoft Word C054555e doc ICS 21 040 10 Ref No ISO 965 3 1998/Cor 1 2009(E) © ISO 2009 – All rights reserved Published in Switzerland INTERNATIONAL STANDARD ISO 965 3 1998 TECHNICAL CORRIGENDUM 1 Pu[.]
Trang 1ICS 21.040.10 Ref No ISO 965-3:1998/Cor.1:2009(E)
© ISO 2009 – All rights reserved
Published in Switzerland
INTERNATIONAL STANDARD ISO 965-3:1998
TECHNICAL CORRIGENDUM 1
Published 2009-07-15
INTERNATIONAL ORGANIZATION FOR STANDARDIZATION • МЕЖДУНАРОДНАЯ ОРГАНИЗАЦИЯ ПО СТАНДАРТИЗАЦИИ • ORGANISATION INTERNATIONALE DE NORMALISATION
ISO general purpose metric screw threads — Tolerances —
Part 3:
Deviations for constructional screw threads
TECHNICAL CORRIGENDUM 1
Filetages métriques ISO pour usages généraux — Tolérances —
Partie 3: Écarts pour filetages de construction
RECTIFICATIF TECHNIQUE 1
Technical Corrigendum 1 to ISO 965-3:1998 was prepared by Technical Committee ISO/TC 1, Screw threads
Page ii, Foreword
Replace the third paragraph with the following:
ISO 965-3 was prepared by Technical Committee ISO/TC 1, Screw threads, Subcommittee 2,
Page 1, Scope
In the first paragraph, second line, replace “according to” with “in accordance with”
Trang 2ISO 965-3:1998/Cor.1:2009(E)
Page 1, Normative references
Delete the references to ISO 68-1, ISO 261 and ISO 965-1
Replace the reference to ISO 5408 with the following:
ISO 5408, Screw threads — Vocabulary
Page 10, Table 1
In the 11th column, which gives the lower deviation, ei, for the pitch diameter of the external thread, replace
“−307”, corresponding to tolerance class 8g and pitch of 2 mm, with “−303”
Page 16
Add the following bibliography at the end of the document, after Table 1:
Bibliography
[1] ISO 68-1, ISO general purpose screw threads — Basic profile — Part 1: Metric screw threads
[2] ISO 261, ISO general purpose metric screw threads — General plan
[3] ISO 965-1, ISO general-purpose metric screw threads — Tolerances — Part 1: Principles and
basic data