15 RF remote control using PT2262 and PT2272 product overview

Both, they work as a remote control for RF or IR modulation.. This module communicates each other using 315 MHz RF Radio Frequency modulation, with 1 side using a RF transmitter and the

4/04/12-POV002

1.0 HE1804

Features:

 RF Modulation

 Low power consumption

 12 tri-state address pins and 6 data pins

 Wide range supply voltage: 4-15V

 Latch and Momentary data output

PT2262 is a remote control encoder, usually paired with PT2272 which is a remote control decoder Both, they work as a remote control for RF or IR modulation This module communicates each other using 315 MHz RF (Radio Frequency) modulation, with 1 side using a RF transmitter and the other side captures transmission with RF receiver The principal on how they work is simple, just make sure that the address both on transmitter and receiver are the same to make them communicate correctly The TE pin on PT2262 must be pulled to low to start sending the data

Pin Out:

Pin Configuration

2 TE(2262) / VT(2272) Transmission Enable (Active Low) / Valid

Transmission

Product Overview

RF Remote Control using PT2262 and PT2272

(COM-IR22X2)

8

PT2272

1

1

8 PT2262

4/04/12-POV002

1.0 HE1804

Schematic:

PT2262

PT2272

4/04/12-POV002

1.0 HE1804

Dimension:

24.64(W) x 58.02(L) mm - Transmitter

24.64(W) x 52.34(L) mm - Receiver

Note: For more detailed information, please refer to PT2262 and PT2272 datasheet

52.34 mm

24.64 mm

58.02 mm

24.64 mm