Use this document as a template if you are using Microsoft Word ver.. If you are using Microsoft Word, use either the Microsoft Equation Editor or the MathType add-on http://www.math typ
Trang 1Paper Title: Capitalize the First Letter in Each Word of Title Except for Prepositions,
Articles and Conjunctions Gil-Dong Hong 1 , Second B Author 2 , and Third C Author 3 1
1Department of _, _ University, City zip-code, Country
2Department of _, _ University, City zip-code, Country
3Division of _, _ University, City zip-code, Country
[Email : kiice@kiice.org]
Abstract
Abstract should be placed here These instructions give you guidelines for preparing
papers for ICFICE2022 Use this document as a template if you are using Microsoft Word ver 10.0
Index Terms: About four key words or phrases in alphabetical order, separated by
commas such as Maritime, Information, Communication, Science, etc
I INTRODUCTION
This document is a template for Microsoft Word ver 2010 If you are reading paper version of this document, please download the electronic file, paper_template(ICFICE2022).docx , from http://icfice.org/ so you can use it to prepare your manuscript
II SYSTEM MODEL AND METHODS
The main text is recommended to be arranged in this order, if possible: Introduction, System Model and Methods, Results, Discussion and Conclusions There are four levels of section headings with established specifications Enumeration of section heads is required
A Secondary Heading
1) Tertiary Heading
a) Quaternary heading:
III RESULTS
A Math
1 Corresponding author
Trang 2If you are using Microsoft Word, use either the Microsoft Equation Editor or the MathType add-on (http://www.math type.com) for equations in your paper “Float over text” should not be selected
B Equation
Number equations consecutively with equation numbers in parentheses flush with the right margin, as in (1)
) ( ) ( )
|
| ( exp
)]
2 ( / [ )
, (
0 2 1 1 0
0 2 0
2
d r J r J z
z
r d
dr r F
i i
j
r
(1)
C Units
Units of measure should be presented according to the International System (SI) of Units English units may be used as secondary units (in parentheses) An exception is when English units are used as identifiers in trade, such as “3½ in disk drive.” All units must be preceded by one space except percentage (%) and temperature (℃)
D Abbreviations
Abbreviations must be used as an aid to the reader, rather than as a convenience of the author, and therefore their use should be limited Generally, avoid abbreviations that are used less than 3 times in the text, including tables and figure legends
IV DISCUSSION AND CONCLUSIONS
A Figures and Tables
All figures, figure captions, and tables should be on separate pages at the end of the paper Large figures and tables may span both columns If your figure has two parts, include the labels “(a)” and “(b)” as part of the artwork Please verify that the figures and tables you mention in the text actually exist
1) Table 1
Each Table should be numbered with Roman numerals in the order of their appearance
in the text Tables should have a concise and informative title with the table content between horizontal lines Vertical lines are not used The structure should be clear, with simple column headings giving all units A table should not exceed one page when printed Use lower case letters in superscripts a), b), c) for special remarks Unaltered computer output and notation are generally unacceptable
Trang 3Table 1 Units for magnetic properties
Sym
Conversion from Gaussian and CGS EMU to SI a
magnetic flux 1 Mx 10 8 Wb = 10 8 V·s
2) Figures
Figures are numbered consecutively in the sequence mentioned in the text and must have a caption written in one paragraph style The caption should contain an explanation
of all abbreviations and symbols used, and indicate the size value of lines or bars unless shown directly on the figure Citations of figures in the text or parentheses are abbreviated, e.g., Fig 1, Figs 1 and 2, Figs 1-3
Fig 1 Comparison between service disruption periods in each protocol: impact of link delay between local mobility anchor (LMA) and mobile access gateway (MAG).
B Electronic Graphics
Preferred file type is vector drawing such as EPS or WMF If bitmap format is used, preferred one is TIF at a resolution of at least 300 dpi for color photos and at least 900 dpi for line art with minimum width of 100 mm (4 inches) Figure should contain only the image and not the caption Figures (line artwork or photographs) should be named fig1.tif
or fig2.eps Please do not use descriptive names
Trang 4C References in Text
References should be obviously related to documents References should be numbered consecutively in the order in which they are first mentioned in the text Each reference should be cited as [1, 4, 7], or [6-9]; Kim [3] and Jang and Lee [5]; Park et al [6]
APPENDIX
Appendixes, if needed, appear before the acknowledgments
ACKNOWLEDGMENTS
Persons or institutes who contributed to the papers but not enough to be coauthors may
be introduced Financial support, including foundations, institutions, pharmaceutical and device manufacturers, private companies, intramural departmental sources, or any other support should be described
REFERENCES
[1] E H Choi, H S Hwang, and C S Kim, “Electron spectroscopy studies on magneto-optical media and
plastic substrate interfaces,” International Journal of Information and Communication Engineering,
vol 9, no 4, pp 358-362, 2011.
[2] J G Proakis, Digital Communications, 4th ed., New York, NY: McGraw-Hill, 1993.
[3] J L Hennessy and D A Patterson, “Instruction-level parallelism and its exploitation,” in Computer
Architecture: A Quantitative Approach, 4th ed., San Francisco, CA: Morgan Kaufmann Pub., pp
66-153, 2007.
[4] A Hashmi, H Berry, O Temam, and M Lipasti, “Automatic abstraction and fault tolerance in cortical
microachitectures,” in Proceeding of the 38th Annual International Symposium on Computer
Architecture, New York: NY, pp 1-10, 2011.
[5] B Alavi, “Distance measurement error modeling for time-of-arrival based indoor geolocation,” Ph.D dissertation, Worcester Polytechnic Institute, Worcester: MA, 2006.
[6] Y Z Ben, D K John, and Anthony, “Tapestry: An infrastructure for fault-tolerant wide-area location and routing,” University of California, Berkeley: CA, Technical Report CSD-01-1141, 2001.
[7] Malardalen Real-Time Research Center, The worst-case execution time (WCET) analysis project [Internet], Available: http://www.mrtc.mdh.se/projects/wcet/
[8] H Nowakowska, M Jasinski, P S Debicki and J Mizeraczyk, “Numerical analysis and optimization of
power coupling efficiency in waveguide-based microwave plasma source,” IEEE Transactions on
Plasma Science [Online], vol 39, no 10, pp 1935-1942, 2011, Available: http://ieeexplore.ieee.org/
xpl/articleDetails.jsp?arnumber=6003795.