Tài liệu Lab 1 1 7 Using ping and tracert from a Workstation ppt

... 1 - 5 CCNA 1: Networking Basics v 3.0 - Lab 1. 1 .7 Copyright  2003, Cisco Systems, Inc. Lab 1. 1 .7 Using ping and tracert from a Workstation Objective • Learn to use the TCP/IP Packet ... Groper (ping) command from a workstation. • Learn to use the Trace Route (tracert) command from a workstation. • Observe name resolution occurrences using W...

Ngày tải lên: 11/12/2013, 13:15

... Ethernet 1 (E1) 16 00 Ethernet 0 (E0) Ethernet 1 (E1) Serial 0 (S0) Serial 1 (S1) 17 00 FastEthernet 0 (FA0) FastEthernet 1 (FA1) Serial 0 (S0) Serial 1 (S1) 2500 Ethernet 0 (E0) Ethernet 1 (E1) Serial ... router and gateway router, and a default route between the gateway router and remote router. Cable a network similar to the one in the diagram above. Any router...

Ngày tải lên: 11/12/2013, 13:15

... Serial 1 (S1) 17 00 FastEthernet 0 (FA0) FastEthernet 1 (FA1) Serial 0 (S0) Serial 1 (S1) 2500 Ethernet 0 (E0) Ethernet 1 (E1) Serial 0 (S0) Serial 1 (S1) 2600 FastEthernet 0/0 (FA0/0) FastEthernet ... interface on the router with an IP address and a subnet mask. Background/Preparation In this lab the Cisco Discovery Protocol (CDP) commands will be used. CDP discovers...

Ngày tải lên: 11/12/2013, 13:15

... Address Ethernet 0 Address Subnet mask (all interfaces) Router 1 GAD DCE 56000 19 2 .16 8 .15 .1 192 .16 8 .14 .1 255.255.255.0 Router 2 BHM DTE Not set 19 2 .16 8 .15 .2 19 2 .16 8 .16 .1 255.255.255.0 ... 2: Routers and Routing Basics v 3.0 - Lab 4 .1. 6 Copyright  2003, Cisco Systems, Inc. Lab 4 .1. 6 Using CDP Commands Objective • Use CDP commands to...

Ngày tải lên: 11/12/2013, 14:15