Lab 3 1 5 Configuring a Serial Interface

... 1 - 5 CCNA 2: Routers and Routing Basics v 3. 0 - Lab 3. 1. 5 Copyright  20 03, Cisco Systems, Inc. Lab 3. 1. 5 Configuring a Serial Interface Objective • Configure a serial interface on each ... (FA1) Serial 0 (S0) Serial 1 (S1) 250 0 Ethernet 0 (E0) Ethernet 1 (E1) Serial 0 (S0) Serial 1 (S1) 2600 FastEthernet 0/0 (FA0/0) FastEthernet 0 /1 (FA0...

Ngày tải lên: 05/11/2013, 12:15

... 3 Configure the London interface as listed Configure the London router serial interface as follows: London(config) #interface serial 0 London(config-if)#ip address 19 2 .16 8 . 15 .1 255 . 255 . 255 .0 ... follows: Paris(config) #interface serial 0 Paris(config-if)#ip address 19 2 .16 8 . 15 .2 255 . 255 . 255 .0 Paris(config-if)#clockrate 56 000 Paris(config-if)#...

Ngày tải lên: 11/12/2013, 13:15

... 1 - 4 CCNA 2: Routers and Routing Basics v 3. 0 - Lab 3. 1. 7 Copyright  20 03, Cisco Systems, Inc. Lab 3. 1. 7 Configuring an Ethernet Interface Objective • Configure an Ethernet interface ... GAD(config-if)#ip address 19 2 .16 8 .14 .1 255 . 255 . 255 .0 GAD(config-if)#no shutdown GAD(config-if)#exit GAD (config)#exit Note: Once interface configuratio...

Ngày tải lên: 11/12/2013, 13:15

... bulb bases or LEDs with resistors • 6v lantern battery 1 - 3 CCNA 1: Networking Basics v 3. 0 - Lab 3. 1. 5 Copyright  20 03, Cisco Systems, Inc. Step 1 Measure the Resistances of all devices Measure ... increase the overall understanding of some of the basic electrical circuit building blocks. Prior to starting the lab, the teacher or lab assistant should have one multimete...

Ngày tải lên: 05/11/2013, 12:15