Lab 7 2 2 Configuring RIP

Lab 7.1.2 Waveform Decoding

Lab 7.1.2 Waveform Decoding

... 1 - 2 CCNA 1: Networking Basics v 3.0 - Lab 7. 1 .2 Copyright  20 03, Cisco Systems, Inc. Lab 7. 1 .2 Waveform Decoding Objective The purpose of this lab is to integrate knowledge ... OSI 7- Layer model with real-world examples • Signaling and Encoding methods (Ethernet Manchester) 2 - 2 CCNA 1: Networking Basics v 3.0 - Lab 7. 1 .2 Copyright  20 03, Cisco Systems, In...

Ngày tải lên: 19/10/2013, 02:15

2 378 0
Tài liệu Lab 7.3.5 Configuring IGRP pptx

Tài liệu Lab 7.3.5 Configuring IGRP pptx

... 1 - 6 CCNA 2: Routers and Routing Basics v 3.0 - Lab 7. 3.5 Copyright  20 03, Cisco Systems, Inc. Lab 7. 3.5 Configuring IGRP Objective • Setup IP an ... there is a problem 2 - 6 CCNA 2: Routers and Routing Basics v 3.0 - Lab 7. 3.5 Copyright  20 03, Cisco Systems, Inc. doing this, refer to the Configuring Router Passwords lab. Next configure ... following:...

Ngày tải lên: 11/12/2013, 14:15

6 406 1
Lab 7.2.2 Configuring RIP

Lab 7.2.2 Configuring RIP

... BHM(config)#router rip BHM(config-router)#network 1 72 . 17. 0.0 BHM(config-router)#network 1 72 .18.0.0 BHM(config-router)#exit BHM(config)#exit 2 - 5 CCNA 2: Routers and Routing Basics v 3.0 - Lab 7. 2. 2 Copyright ... ip route output eliminated Gateway of last resort is not set C 1 72 .16.0.0 /24 is directly connected, FastEthernet0 C 1 72 . 17. 0.0 /24 is directly connected, Seri...

Ngày tải lên: 04/11/2013, 16:15

5 385 0
Tài liệu Lab 7.2.6 Troubleshooting RIP ppt

Tài liệu Lab 7.2.6 Troubleshooting RIP ppt

... Lab 7. 2. 6 Troubleshooting RIP Objective • Set up an IP addressing scheme using class B networks. • Configure RIP on routers. • Observe routing activity using the debug ip rip command. ... __________________________________________________________________________ 2 - 5 CCNA 2: Routers and Routing Basics v 3.0 - Lab 7. 2. 6 Copyright  20 03, Cisco Systems, Inc. c...

Ngày tải lên: 11/12/2013, 14:15

5 403 0
Lab 7.2.4 Selecting the Root Bridge

Lab 7.2.4 Selecting the Root Bridge

... 1 - 6 CCNA 3: Switching Basics and Intermediate Routing v 3.0 - Lab 7. 2. 4 Copyright  20 03, Cisco Systems, Inc. Lab 7. 2. 4 Selecting the Root Bridge Objective • Create a basic switch ... gateway as on the switch. Step 3 Verify connectivity 2 - 6 CCNA 3: Switching Basics and Intermediate Routing v 3.0 - Lab 7. 2. 4 Copyright  20 03, Cisco Systems, Inc. a. To ver...

Ngày tải lên: 05/11/2013, 12:15

6 398 0
Tài liệu Lab 1.2.5 Verifying RIP v2 Configuration pdf

Tài liệu Lab 1.2.5 Verifying RIP v2 Configuration pdf

... address 1 72 .16.1 .2 255 .25 5 .25 5.0 BHM(config-if)#exit BHM(config)#interface fastethernet 0 BHM(config-if)#ip address 1 72 .16.3.1 25 5 .25 5 .25 5.0 BHM(config-if)#exit BHM(config)#exit 4 - 7 CCNA ... GAD from a class B (25 5 .25 5.0.0) to a Class C (25 5 .25 5 .25 5.0). Use the same IP address. GAD(config)#interface fastethernet 0 GAD(config-if)#ip address 1 72 .16.0....

Ngày tải lên: 11/12/2013, 13:15

7 559 0
w