Lab 3 3 3 Configuring PPP Authentication

... Lab 3. 3 .3 Configuring PPP Authentication Objective • Configure a PPP authentication using CHAP on two routers. Background/Preparation ... WAN Technologies v 3. 0 - Lab 3. 3 .3 Copyright  20 03, Cisco Systems, Inc. Start a HyperTerminal session as. Note: Refer to the erase and reload instructions at the end of this lab. Perform those ... lab. Perform those ste...

Ngày tải lên: 16/10/2013, 20:15

... 1 - 5 CCNA 3: Switching Basics and Intermediate Routing v 3. 0 - Lab 2 .3. 4 Copyright  20 03, Cisco Systems, Inc. Lab 2 .3. 4 Configuring OSPF Authentication Objective ... troubleshoot as necessary. 3 - 5 CCNA 3: Switching Basics and Intermediate Routing v 3. 0 - Lab 2 .3. 4 Copyright  20 03, Cisco Systems, Inc. Step 7 Setup up OSPF authentication a. OSPF authe...

Ngày tải lên: 24/01/2014, 19:20

... 1 - 6 CCNA 2: Routers and Routing Basics v 3. 0 - Lab 3. 1 .3 Copyright  20 03, Cisco Systems, Inc. Lab 3. 1 .3 Configuring Router Passwords Objective • Configure a password ... GAD(config)#exit Step 8 Return to the user exec mode 3 - 6 CCNA 2: Routers and Routing Basics v 3. 0 - Lab 3. 1 .3 Copyright  20 03, Cisco Systems, Inc. GAD#disable Step 9 Ent...

Ngày tải lên: 23/10/2013, 00:15

... 1 - 5 CCNA 2: Routers and Routing Basics v 3. 0 - Lab 3. 1.5 Copyright  20 03, Cisco Systems, Inc. Lab 3. 1.5 Configuring a Serial Interface Objective • Configure a serial ... shown in the diagram. This lab requires a null serial cable and two rollover or console cables. 2 - 5 CCNA 2: Routers and Routing Basics v 3. 0 - Lab 3. 1.5 Copyright  20 03, Cisco Systems,...

Ngày tải lên: 05/11/2013, 12:15

... 1 - 4 CCNA 2: Routers and Routing Basics v 3. 0 - Lab 3. 1.7 Copyright  20 03, Cisco Systems, Inc. Lab 3. 1.7 Configuring an Ethernet Interface Objective • Configure ... previous steps, logoff by typing exit. Turn the router off. 3 - 4 CCNA 2: Routers and Routing Basics v 3. 0 - Lab 3. 1.7 Copyright  20 03, Cisco Systems, Inc. Erasing and reloading the router En...

Ngày tải lên: 11/12/2013, 13:15