Lecture Autodesk inventor Parametric modeling An introduction
An introduction to disk drive modeling
... The controller manages the storage and retrieval of data to and from the mechanism and performs mappings between incoming logical addresses and the physical disk sectors that store the information ... Bruce Worthington and Greg Ganger at the University of Michigan took this approach and managed to fine-tune the controller-overhead and bus-transfer components of a model similar to ours...
Ngày tải lên: 12/09/2012, 14:16
An Introduction to Intelligent and Autonomous Control-Chapter 5: Modeling and Design of Distributed Intelligence Systems
Ngày tải lên: 07/11/2013, 09:15
Tài liệu An Introduction to Intelligent and Autonomous Control-Chapter 8: Modeling and Analysis of Artificially Intelligent Planning Systems ppt
Ngày tải lên: 14/12/2013, 12:15
an introduction to network modeling and simulation for the practicing engineer
... Network Modeling and Simulation for the Practicing Engineer Jack Burbank, William Kasch, Jon Ward AN INTRODUCTION TO NETWORK MODELING AND SIMULATION FOR THE PRACTICING ENGINEER Jack Burbank William ... relatively constant over the transmission of the message From Table 2-3, the IEEE 802.11 b and g channel bandwidth both exceeds and is below the...
Ngày tải lên: 02/04/2014, 15:49
Chapter 1: An Introduction to Inventor Simulation ppt
... Plane CHAPTER An Introduction to Inventor Simulation Automatically convert standard joints and rolling joints Here , we will create automatic joints from assembly constraints and attempt to analyze ... you cannot weld components together that have joints already defi ned between them Select NC-Ball:1 and NC-Rope1:1 Right Click and select Weld parts 19 CHAPTER An Introduction...
Ngày tải lên: 05/07/2014, 19:21
An Introduction to Modeling and Simulation of Particulate Flows Part 5 potx
... TOTAL KINETIC ENERGY TOTAL KINETIC ENERGY 0. 65 ENERGY (N-m) 0.7 0. 65 ENERGY (N-m) 0.7 0.6 0 .55 0.6 0 .55 0 .5 0 .5 0. 45 0. 45 0.4 0.4 0 .5 1 .5 2 .5 3 .5 4 .5 0 .5 1 .5 TIME 2 .5 3 .5 4 .5 TIME 0. 75 0. 75 TOTAL ... ENERGY TOTAL KINETIC ENERGY 0.7 0. 65 0. 65 ENERGY (N-m) 0.7 ENERGY (N-m) 05 book 2007 /5/ 15 page 71 ✐ 0.6 0 .55 0.6 0 .55 0 .5 0 .5 0. 45 0. 45 0.4...
Ngày tải lên: 06/08/2014, 01:21
An Introduction to Modeling and Simulation of Particulate Flows Part 6 pps
... w1 + w + w + w w1 TOLr + w2 TOLθ + w3 TOLrf + w4 TOLθf ; w1 + w + w + w TOLtot = (c) K = def TOLtot Etot,0 Etot,K Etot,0 pKd pK ; (5) IF TOLERANCE MET (Etot,K ≤ 1) AND K < Kd , THEN ... Advanced particulate flow models 4e+08 TOTAL X NORMAL FORCE TOTAL Y NORMAL FORCE TOTAL Z NORMAL FORCE TOTAL X TANGENTIAL FORCE TOTAL Y TANGENTIAL FORCE TOTAL Z TANGENTIAL FORCE 3e+08 2e+08 TOTAL ....
Ngày tải lên: 06/08/2014, 01:21