Robotics 2 E Part 5 pptx

... opposite partition E, which has two channels 1 and 2. The pressure difference between these channels depends upon the position of the edge of the nozzle D relative to the inlets of ... i m 2 FIGURE 3E- 4a) the time needed to achieve a speed of the piston V= 2m/sec when the height of the mass increases; find the distance travelled by the piston. At th...

Ngày tải lên: 11/08/2014, 21:22

... the vehicle repeats these movements. Such a vehicle becomes more cumbersome as the number of legs is increased. A four-legged lorry built by General Electric, which weighs 1 ,50 0 ... would seem that the most effec- tive one is so-called seam resistance welding. This process requires much more sophis- ticated equipment than soldering does. There are differences between...

Ngày tải lên: 11/08/2014, 21:22

... pressure in the receiver 1, T r = absolute temperature of the air in the receiver, 3.3 Electric Drives 87 and its expansion into a Fourier series becomes where r is the torque ... drive, one which must reduce the speed of a moving element until complete cessation of movement of the element is achieved, i .e. , a brake system. Such a mechanism must be able...

Ngày tải lên: 11/08/2014, 21:22

... permanent magnet 1 fastened to the moving element and an immovable coil 2. When relative movement occurs between these two elements, an electromotive force (EMF) appears in the ... the measured part, saving time and money. Exercises 173 from each accelerometer is doubly integrated and amplified. Thereafter, the obtained power signal enters the active damper ....

Ngày tải lên: 11/08/2014, 21:22

... However, this makes the feeder very sensitive to minor differences between the excitation and natural frequencies. These differences are caused by diffi- culties in making the ... the following empirical relationships between the dimensions of the parts and the slot parameters are recommended: A very similar feeding device is the knife hopper, a representa...

Ngày tải lên: 11/08/2014, 21:22

... flat details due to the difference between the center of mass and the geometric center. 27 0 Feeding and Orientation Devices FIGURE 7 .53 Active orientation of needle-like details. FIGURE ... to its other side. Thus, every part is handled and sooner or later achieves the desired orientation. Often the difference between the geometrical center and the center...

Ngày tải lên: 11/08/2014, 21:22

... time losses due to unexpected damages and their reappearances. 8.3 Special Means for Assembly 29 5 FIGURE 8 .22 Simple model of an assembly process. of assembly. We define the ... assembling, use either cases c) or d), where the design is symmetrical, or case e) , where the asymmetry is emphasized to make the difference A large enough for convenie...

Ngày tải lên: 11/08/2014, 21:22