Learning AutoCAD 2010, Volume 1 phần 10 pot

... Objects 11 . To select a door to relocate within a wall: ■ Start the Stretch command. ■ Click near point (1) and then point (2) to define the crossing window. ■ Press ENTER. 12 . ... ■ 403 10 . To move this object to the Hidden2 layer: ■ On the Layers panel, click the Layers list. ■ Click the Hidden2 layer to move the selected object to this layer. 11 ....

Ngày tải lên: 09/08/2014, 11:20

... ESC to clear the selected line. 10 . Select a dimension in the drawing. The Quick Properties panel automatically displays two property rows. 11 . On the status bar, right-click ... 12 . In the Drafting Settings dialog box, Quick Properties tab, under Palette Behavior, clear the check mark for the Collapse Palette Automatically option. Click OK. 13 ....

Ngày tải lên: 09/08/2014, 11:20

... circles 2 and 3 = 10 3.9447 mm Distance between circles 2 and 4 = 10 5.6296 mm 11 . Angle = 13 1 degrees Delta Y = 44.9275 mm 13 . X = 253 .13 53Y = 0.0000Z = 0.0000 14 . Net area ... Distance = 55 mm Angle = 212 degrees 4. Radius for circle 2 = 17 .25 mm Radius for circle 4 = 10 .00 mm 5. Object type = LWPOLYLINE Area = 17 64.00 mmPerimeter =...

Ngày tải lên: 09/08/2014, 11:20

... Objects 10 . To remove the construction lines: ■ Start the Erase command. ■ Select the lines indicated in the following image. Press ENTER. 11 . Your completed drawing. 12 . ... (1) . ■ Select the object to join (2). ■ Press ENTER to complete the command. 5. To Join the arc segments and close them. Method 1: ■ Begin the Join command. ■ Select on...

Ngày tải lên: 09/08/2014, 11:20

... select 0'-0 1/ 8". ■ In the Precision list under Angle, select 0.0. ■ Click OK. 3. To draw a line: ■ On the Home tab, click Draw panel > Line. ■ Enter 10 ' ,10 '. Press ... with Units ■ 14 7 11 . For the next point: ■ Move the cursor to the left. ■ Enter 44'-5". Press TAB. ■ Enter 18 0. Press TAB. ■ Click anywhere in the drawing....

Ngày tải lên: 09/08/2014, 11:20

... left corner as the basepoint. ■ Enter a rotation angle of 10 . Press ENTER. ■ Notice that the object is rotated 10 degrees counterclockwise. 18 4 ■ Chapter 3: Manipulating Objects 8. To position ... variable set to 1. 1. Begin by setting the MIRRTEXT system variable to 1. This turns the mirroring of text on. ■ At the Command line, enter MIRRTEXT and press ENTER....

Ngày tải lên: 09/08/2014, 11:20

... 2 21 Practice Exercise: Creating an Array of Objects In this practice exercise, you draw a 1 x 1 rectangle and create an array using the Polar and Rectangular array options. 1. ... Introduction in Volume 1. Lesson: Creating Object Patterns ■ 219 Procedure: Creating a Polar Array of Objects The following steps are an overview of creating polar arrays. 1...

Ngày tải lên: 09/08/2014, 11:20