Learning AutoCAD 2010, Volume 1 phần 6 doc

... 2 21 Practice Exercise: Creating an Array of Objects In this practice exercise, you draw a 1 x 1 rectangle and create an array using the Polar and Rectangular array options. 1. ... Introduction in Volume 1. Lesson: Creating Object Patterns ■ 219 Procedure: Creating a Polar Array of Objects The following steps are an overview of creating polar arrays. 1...

Ngày tải lên: 09/08/2014, 11:20

... symbol is typed. Example 16 ' -2" can be simply typed: 16 '2 ■ When using Architectural units, you may type 16 ' -2" or the equivalent in inches: 19 4 ■ If you work primarily ... 9. Position the cursor so that the polar angle tooltip reads 15 .00 < 315 . Click the point. 16 6 ■ Chapter 3: Manipulating Objects Selecting with a Crossing...

Ngày tải lên: 09/08/2014, 11:20

... variable set to 1. 1. Begin by setting the MIRRTEXT system variable to 1. This turns the mirroring of text on. ■ At the Command line, enter MIRRTEXT and press ENTER. ■ Enter 1 and press ENTER. ... for the new angle. For instance, if point (2) was selected before point (1) , the new angle would have been 18 0. 2 06 ■ Chapter 3: Manipulating Objects Mirroring Objects...

Ngày tải lên: 09/08/2014, 11:20

... ESC to clear the selected line. 10 . Select a dimension in the drawing. The Quick Properties panel automatically displays two property rows. 11 . On the status bar, right-click ... thelist on the Properties panel. 1. Select one or more objects in your drawing that need to have their color changed. Lesson: Using Layers ■ 267 Practice Exercise: Layer Tool...

Ngày tải lên: 09/08/2014, 11:20

... circles 2 and 3 = 10 3.9447 mm Distance between circles 2 and 4 = 10 5 .62 96 mm 11 . Angle = 13 1 degrees Delta Y = 44.9275 mm 13 . X = 253 .13 53Y = 0.0000Z = 0.0000 14 . Net area ... Distance = 55 mm Angle = 212 degrees 4. Radius for circle 2 = 17 .25 mm Radius for circle 4 = 10 .00 mm 5. Object type = LWPOLYLINE Area = 17 64 .00 mmPerimeter...

Ngày tải lên: 09/08/2014, 11:20

... Objects 10 . To remove the construction lines: ■ Start the Erase command. ■ Select the lines indicated in the following image. Press ENTER. 11 . Your completed drawing. 12 . ... (1) . ■ Select the object to join (2). ■ Press ENTER to complete the command. 5. To Join the arc segments and close them. Method 1: ■ Begin the Join command. ■ Select one...

Ngày tải lên: 09/08/2014, 11:20

... lengths at 1 for the same results. 3. To chamfer using the polyline option: ■ Draw another 8 x 6 rectangle (see #1) . ■ Begin the Chamfer command. ■ See that the current chamfer length is 1 and ... Objects 11 . To select a door to relocate within a wall: ■ Start the Stretch command. ■ Click near point (1) and then point (2) to define the crossing window. ■ Press ENTER....

Ngày tải lên: 09/08/2014, 11:20