Machinability and Surface Integrity Part 7 pptx
Machinability and Surface Integrity Part 7 pptx
... Figure 172 . Typical temperature distributions (isotherms) during machining, illustrated across the: chip, insert and work- piece; at relatively low cutting speed . Machinability and Surface Integrity ... capture and analysis covers these and other related parameters and clearly indicates the power of simulation – more will be mentioned on this subject later in the chapt...
Ngày tải lên: 05/08/2014, 21:20
Machinability and Surface Integrity Part 4 pps
... deviation of a sample from a production batch run. Machinability and Surface Integrity depending upon whether a ne, medium, or coarse surface texture is obligatory. Due to the variability ... ‘stochastic out- put’ 47 , such surface texture values do not reect the likely in-service performance of the part. Neither the surface topography, nor its associated integrity...
Ngày tải lên: 05/08/2014, 21:20