Machinability and Surface Integrity Part 4 pps
Machinability and Surface Integrity Part 4 pps
... when high-speed machining. Machinability and Surface Integrity mentally increased to point ‘e’ 34 – this being a ‘safe- limit’ for the optimum machining operation. 7 .4 Milled Roundness – Interpolated ... at best, only its partial aect would be present here, on this diagram. e ‘Lay’ of a surface tends to be either: anisotropic, or isotropic 44 in nature on a machined...
Ngày tải lên: 05/08/2014, 21:20
Machinability and Surface Integrity Part 7 pptx
... (isotherms) during machining, illustrated across the: chip, insert and work- piece; at relatively low cutting speed . Machinability and Surface Integrity Figure 173. Finite Element Method (FEM), to ... – is usually the re- sult of tool/workpiece anity associated with tem- Machinability and Surface Integrity perature and its respective cutting speed (i.e. see Fig...
Ngày tải lên: 05/08/2014, 21:20